Spark plug OEM FORD or AC DELCO

In my personal experience (99 suburban 6.2l 383) AC Delco spark plugs are the way to go

My 2000 Ford Ranger with a 4-cylinder and manual is just about the simplest vehicle that could exist. SOHC engine, so not much that can go wrong in it. It's very satisfying to work on because you don't experience the shitty feeling of knowing you spent way longer on something than it should have taken.

I have ACDelcos in my 2010.

I've changed them twice over the 120k or so that I've had the car and I didn't pay attention to what was in it when I bought it, but the person who owned the car before me had a receipt from Advance.

New Denso wires (these were the OEMs, cheaper to not pay ac delco mark up) and AC-Delco 41-962 plugs.

AC Delco/NGK.

IMHO, this is one of the times where the OEM stuff might be the best way to go, especially if your engine is otherwise stock. It's really common to see these trucks get well over 150,000 out of the original plugs and wires. They're kind of expensive but they just last so long it's worth it.

Acdelco plugs....Never had problems with either

Until I replaced the plugs, coils, alternator, starter, battery and cleaned connections all I could, this problem persisted and my vehicle killed a coil / 2 every season.

2005 CVPI...180,000 mi....spark plug blown out of head. The Crown Vic was purchased at auction for $4200 a bunch of years ago with 100,000 miles and was very good to us until about a week ago...original engine, suspension parts, transmission and very few repairs.

I initially got the P0101 code and did the obvious - replaced the MAF sensor. No change, same codes. Goodbye $100.

I have a 1986 blazer and replaced the spark plugs with ac delco factory spark plugs purchased from napa, about 2 months later I was driving the vehicle and the vehicle had a miss then starting blowing out oil from the Pcv vlave from excessively high crank case pressure after electrode fell out.