I did Bosch quiet cast pads and rotors on the front on my 12 a couple months back. I’m happy with them.
Brembo, bosh and a few others mentioned in another comment are all really good too.
I got the Bosche pads. I think they were in a higher category than daily but the front+back together ended up being cheaper then other brands I was looking at. Just make sure you get ones clearly labeled front or back, and Japan built.
I got BREMBO rotors and Bosch quiet cast pads, happy with the purchase.
I was very happy with Bosch BP621 brake pads. It had excellent grip.
Look on rockauto, and look for the brand called bosch, they kick ass and are oem quality
I went with Raybestos rotors and Bosch QuietCast pads. Equal if not better than OEM and much much cheaper.
So I followed their direction and jumped on the old interwebs to my retailer of choice, RockAuto, and ordered Bosch pads and rotors front and back. So I had nothing planned for the weekend figured I would do a little wrenching. Take the wheels off and start to unbolt the caliper, looked down and my rear pads still show about half life. Maybe they just meant the fronts, pop the wheel and they are showing even less wear. My question is it normal for the CX-5 to go 80000 miles on the original pads? I didn't think I drove like my grandmother but it is 70% highway/non city driving. For anyone that does your own maintenance the cost for 4 rotors and pads was less than $200 (Raybestos Element 3 rotors and Bosch Quiet Cast ceramic pads). It really a fairly easy job, and would not take more than 30 minutes per wheel.
I replaced front pads and rotors on my Tiguan, and afterwards, when going between D <-> R and applying the brakes, the first brake application causes a "clack" on both sides at the front. Pads are Bosch 1633A. spring clips (integral to pads) are seated properly. Pads and rotors were bedded properly. Wheel lug bolts torqued properly. I have the official instructions from VW. I've probably done ~20 brake jobs in my life, mostly Volvos (over half of those were sliding-caliper designs like the Tiguan's). What I tried (with no success): searching and searching and searching forums, only found 2 other people with a similar issue on FCP's Brake Replacement YouTube video measured and compared all latereral dimensions of the pad's plate between new and old, same dimensions re-installed the pads all bolts are torqued properly (caliper carrier 200 Nm; caliper pin bolts 35 Nm) found a Tech Bulletin from VW that mentions there are inner- and outer-specific orientation for the pads. This appears to apply only to the Genuine (labeled TRW) pads, as all 3 Bosch pads are identical in every way that I can discern bought a set of Genuine VW pads (labeled VW), ensured the correct orientation of pads according to the Tech Bulletin, and they still clack. pad backing plate dimensions are the same as the Bosch. Ack! More money! bought a set of genuine caliper carriers (with the thinking that perhaps when I wire-wheeled the old caliper carriers to remove rust, it took off too much material). I didn't install them because I measured all the dimensions that interface with the pads and the new are identical to the old.
I had bendix on my cars before, the gen CT and metal king has too much metal components, hence its noisy and scratches the rotors.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
