A good street and occasional track pad is carbotech bobcat
LoyalSage, yesterday i installed my new brake stuff. that would be Adam's slotted rotors with zinc, Carbotech Bobcat 1521 pads (semi-metallic), and the Tyrol kit. i'm possibly not finished with wearing off the zinc, but i'm pretty sure i'm in stable territory now. about 70-80 miles since install. ok my impressions: definite improvement with linearity of braking. OEM tends to overgrab on initial bite, go soft a bit at about 20%, then dig in hard again at about 30-40%, which makes smooth modulation too difficult. the Bobcats grab less on initial contact, and are relatively much more linear down to about 80% (as hard as i have braked since installing). the feel is more firm all the way as well... more feel of the friction at the pedal. if anyone was looking for good pads for this car, i think i found 'em. they obviously work well with Adam's rotors, as this combo is much nicer than OEM IMHO. but, to be honest, i think the modulation you want will not be found here. i think i know what you're looking for, and while this is an improvement, it's not like a multi piston setup.
oh and i replaced my craptastic wagner thermoquiet pads with bendix pads much better feeling on the pad and the calipers dont seem to get so hot
I've got the Carbotec bobcats, They are a nice pad.
However the cold bite of the ax-6 is far superior to the xp10 for street and auto-x, and in my opinion far better than what my oem pads felt like and far more than the hps.
Carbotech XP10's are great for the track, but for daily driving they won't heat up enough to give you the stopping power that they are capable of. They also sqeal like crazy if they are not hot.
I am very happy with the Bobcats for street only
I received my new pads from Carbotech and will put them on this weekend.
Yeah, I went with all new pads and rotors on all 4 corners. Bendix OEM replacements in the front and Duramax in the rears (I know I know...but I am poor ) I know some pads are better than others but beyond a certain point pads are pads are pads right?
I put in some new rear brake pads today. The frist brakes I had were Autozone brand. Well, they went on fine on the driver side. On the passenger side It was near impossible to push the piston back far enough to get the pads on. I still needed about another 1/16th of an inch. I even bled brakes a little to make room for the piston compression. Still no luck. So I went back and bought some Bendix that were about 1/16th less in thickness. So, I put them on the passanger side. I had to wrestle with the piston again - that mofo would not budge. Finally I got it. So, I go for a drive with Albany brakes on one side and Bendix on the other. A horrible scaping erupts from the driver's side. The side that went on much easier. Visual inspection looked ok. So I took them off and they were all scraped to heck. Strange, as that was the easy side. So, I put the Bendix pads on that side and everything is fine.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
