Brake pads Ferodo or Raybestos
I run DS3.12 now and ran DS1.11 on my previous car on track and love them (better then PFC-08)
My stock OEM pads are Ferodo DS2500 and I love them for daily and light track days.
Personally, I’m a fan of Ferodo, but I typically need to get them from the UK.
I always recommend the Raybestos Element3 EHT pads and rotors. We use them at work and have very little comebacks. Low noise, low dust, great pedal feel.
The AP Racing kit was installed with a set of Ferodo DS2500s in the front and stock OEM pads installed fresh in the rear.
I did tons of research and settled on Ferodo DS3.12 (FCP4425G) in front and DS1.11 (FCP4697W) rear with Castrol SRF fluid. Stock R calipers and rotors have held up as well as any aftermarkets I read about for MUCH less $. Zero issues, and cheap.
I've had good results with Ferodo DS2500 pads. More torque than stock, dusting about the same.
I usually get aftermarket Raybestos pads if/when available.
For my 987 the pagids would squeal the most. PFC08 weren’t as bad with similar performance. If you want a hybrid street/track pad that will be pretty quiet on the street (as long as you bed properly) the Ferodo DS2500 is not bad, just be aware if you’re tracking on them at a good pace under heavy braking they can wear quickly. I ran them at the glen and was able to get maybe 3 good days out of a set.
I run the Sebro slotted rotors with Ferodo DS3.12s on track, which are louder than a school bus on the street, so I swap back to OEM pads and rotors after each event.
Write your review
Help others - share your experience with this part.