Was doing control arms for my then boss at the time on his Toyota Sienna.
Vehicle:
Toyota Sienna
Owner reviews for control arm
Manufacturers
Comparisons
Febi's usually have great quality, fitment and durability.
Pros: great quality, good fitment
Ich habe mehrere Teile von Ridex in meinem Auto verbaut und kann mich ehrlich nicht beschweren. Habe unter anderem Querlenker, Anlasser und Innenraumlüfter sowie diverse kleinere Teile von der Marke. Noch ist nix kaputt gegangen
Pros: keine Ausfälle, gute Funktion
The aluminum lower control arm and knuckle removes about 7 to 8 lbs. of unsprung weight from each corner in the front. It doesn't sound like much but it makes a big difference in how the car feels. The whole front end feels lighter, and weight transfers feel faster from side to side.
Pros: lighter front end, faster transfers
Vehicle:
Volkswagen
He lifted the car up and identified that it was the outer bolt on the control arm. So I will replace the control arm myself on both sides. You only need to buy one part (per side) and the replacement is simple as shown here. If you want to check if you have the same issue, you must lift the car and pull down near the outer bolt on the control arm. Mine moves about a centimetre, meaning the ball inside is exhausted. It should not move at all.
Pros: simple replacement, ball joint worn
Cons: worn ball joint
Vehicle:
Nissan Leaf
I used Meyle control arms on my B5 A4 and had no issues after replacement.
Pros: no issues
Vehicle:
Audi A4
Lemforder control arms are the best OE/OEM option.
Pros: best OE/OEM option
I have a July 2018 Model 3 with 95,000 miles. Had one upper control arm replaced under warranty at 36,000 miles. I had to pay $400 to replace the other one at 53,200 miles.
Pros: few other repair costs
Cons: had to pay $400
Mileage: 152887 km
Last summer, I bought a set of AC Delco control arms for a '72 Mustang. The balljoint on the driver's side arm lasted less than 500 km...
Pros: AC Delco control arms
Cons: balljoint lasted less
Vehicle:
Ford Mustang
Mileage: 500 km
I put Meyle HD lower arms on my Z3 two years ago, and this week I've noticed a slight clunking from the front. I've done around 6k in the last two years so perhaps the quality is deteriorating.
Cons: slight clunking, quality deteriorating
Vehicle:
BMW Z3
Mileage: 6000 km
Write your review about control arm
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page