I’ve used them for brake pads, rotors, and spark plugs. I haven’t had a problem with them.
On my car, smooth and quiet, no problems.
I've never used their rotors, but I liked the Quietcast pads when I had them, I never noticed any sound from them.
Depends on which Bosch part specifically.
Bosch brake parts are fine.
I use these on my Jetta, work great. Pads don’t last as long as OEM, but ????♂️
I went with Bosch Quiet off Amazon. I just cruise around and they work fine and are quiet.
I just switched to R1 concepts Geomet pads, and drilled and slotted rotors. They're just as good as OEM from what I can tell.
Bosch’s Quietcast brakes have never done me wrong. I’ve used them in three vehicles now and had good pad life and performance on a budget. No squeaks, decent life for ceramics.
I replaced front pads and rotors on my Tiguan, and afterwards, when going between D <-> R and applying the brakes, the first brake application causes a "clack" on both sides at the front. Pads are Bosch 1633A. spring clips (integral to pads) are seated properly. Pads and rotors were bedded properly. Wheel lug bolts torqued properly. I have the official instructions from VW. I've probably done ~20 brake jobs in my life, mostly Volvos (over half of those were sliding-caliper designs like the Tiguan's). What I tried (with no success): searching and searching and searching forums, only found 2 other people with a similar issue on FCP's Brake Replacement YouTube video measured and compared all latereral dimensions of the pad's plate between new and old, same dimensions re-installed the pads all bolts are torqued properly (caliper carrier 200 Nm; caliper pin bolts 35 Nm) found a Tech Bulletin from VW that mentions there are inner- and outer-specific orientation for the pads. This appears to apply only to the Genuine (labeled TRW) pads, as all 3 Bosch pads are identical in every way that I can discern bought a set of Genuine VW pads (labeled VW), ensured the correct orientation of pads according to the Tech Bulletin, and they still clack. pad backing plate dimensions are the same as the Bosch. Ack! More money! bought a set of genuine caliper carriers (with the thinking that perhaps when I wire-wheeled the old caliper carriers to remove rust, it took off too much material). I didn't install them because I measured all the dimensions that interface with the pads and the new are identical to the old.
I originally had r1 concepts rotors and pads but the pads started to squeak like crazy at slow speeds. Rotors were still good so I put on akebono pads and they are perfect.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
