I think the Bosch pads work fine.
Last year a shop replaced the rear brake pads and disks but since then handbrake never was like before. They kept telling me it will get better which I believed at the time but it never did. Last month I've passed inspection and they told me that the rear left handbrake was almost out of spec and I'd need to check it out although it passed.
So a month later I've bought a Bosch kit, sliders, pads, grease, toolkit etc and replaced the 1 year old ferodo pads. Now handbrake is like it should be and I'm happy with it but take a look at the old pads...
Both inner side alignment pins (caliper side) are bent.
Last month I've passed inspection and they told me that the rear left handbrake was almost out of spec and I'd need to check it out although it passed. So a month later I've bought a Bosch kit, sliders, pads, grease, toolkit etc and replaced the 1 year old ferodo pads. Now handbrake is like it should be and I'm happy with it but take a look at the old pads...Both inner side alignment pins (caliper side) are bent.
I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps
XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this
I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.
carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.
Bosch quiet cast or Zimmerman. Also Bosch blue pads, ceramic if you want clean and semi metallic if you want to stop
I run carbotech xp8 on the front of my c5. Still a group 2 level driver. They’re a good pad for a car that’s driven to the track and home, but dirty and noisy at times for a street pad. They’re considered entry level track pads. I chew up rotors but don’t get fade, but my local tracks aren’t particularly hard on brakes
I ordered Bosch brake pads after installing them. I noticed a knocking sound and if you look in the pic there’s a gap at the top and bottom of the ears on the pad. I threw my old pads away so I couldn’t even compare them. Only when driving really slow then braking or in reverse. Didn’t do it every time but the noise is driving me crazy. I also installed new rotors front and back and it’s only the front driver side making that noise.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
