Brake pads Carbotech or OEM Chevrolet
I run carbotechs on my GT350. Multiple weekends on them.
Been running carbotechs on my m2comp and C's and 2 seasons. Love them. Xp10 up front, xp8 for the rear. Track only pads that I can drive to the track with
the pads on my Bolt lasted 130,000 miles
I’ve had my 2024 over a year and 30,000 km’s. I just had my brakes cleaned and the back up squeal is gone.
I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.
I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps
XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this
My Equinox has 10,400km and will always make noise under braking at the beginning of the ride and then gradually stops. Braking feels good though.
I use carbotech xp8s. Dtc 60 or 70s would also be a good choice. Be warned through track pads driven on the street will accelerate rotor wear. I hated the Ferodo ds2500s when cold.
Chevrolet. One of the issues the car had was when it would rain. The brakes wouldn't always work.
Write your review
Help others - share your experience with this part.