I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps
XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this
I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.
carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.
At 75K went with OEM rotors in the rear and some Wagner QS ZD1108 ceramic pads. Then went with some Brembo 09.C306.11 rotors in the front with EBC Reds ceramic pads. I don’t track. Stopping power is about the same. I didn’t notice a huge difference. What I did notice, much quieter stopping and NO MORE BROWN BRAKE DUST. Yes, still get brake dust but not nearly as much. And when it collects, it’s more of a light white dust. Easy to clean. Super happy with the change. Even in the winter, stopping power is good.
I’ve used carbotech XP10 for years because it’s the only pad that has never had any of these kinds of problems. Also also swapped between 1521 and XP10 seamlessly. The only time I had a problem like this was when I used some very cheap rotors that couldn’t handle the track abuse, you could actually see the rotor surface getting pitted. Yours look fine by comparison.
For my GR86 Carbotech XP10s have been amazing on the track, seriously no complaints at all. The XP10s with Castrol SRF have been a great combo and held up really well even on some really big/high speed tracks. I swap in my OEM pads when I’m not tracking the car for awhile. It’s not great because I have to bed the pads every time I change them. Once I’m through the OEM pads I’m going to get the Carbotech 1521’s for the street, that way like you mentioned I think I can avoid having to avoid bedding my brakes with every change. The XP10’s function well on the street but they feel a little rough if not up to temp and they are insanely loud.
I personally use Carbotech XP10 for track and Stoptech Sport pads for street on the same rotors
I use carbotech xp8s. Dtc 60 or 70s would also be a good choice. Be warned through track pads driven on the street will accelerate rotor wear. I hated the Ferodo ds2500s when cold.
I ran into some brake issues. The pedal started getting squishy even in wet conditions. It never got dangerously deep, but it was still unpredictable. In the last session, the track dried up and I was able to push. I experienced somewhat serious fade. I had to absolutely stand on the brake pedal to get the car stopped. After pulling into the paddock and circling around to let the car cooldown, I still smelled brakes for the next 20+ minutes. The pedal firmed up on the way home.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
