Brake pads EBC or Ferodo
Been using EBC Yellow Stuff for about a month now and love em. At the same time I got Continental summer tires put on as well. It's crazy how much more braking power this set up gas, however you may have to get used to the firmness, took me a couple weeks to soft stop again without a minor jerk when finally stopped, and I notice tire nose more now as well.
I would also recommend the Yellowstuff pads. They are a bit more expensive than the reds, but worth it. I've cooked my red stuffs a few times and the yellows seemed to be much more temperature resilient, I'll be switching back when these die. I also didn't experience any less cold bite from the yellows compared to the reds, which is important on a street pad.
I've always run EBC YellowStuff, and paired them with DBA 4000 T3 rotors, on all my cars, even before I did the STi Brembo swap on my WRX.
For regular use as a daily driver with regular spirited driving I really like EBC yellow pads. Honestly, those pads combined with StopTech rotors has been a great upgrade for my daily-driven car.
EBC pads, OE quality Zimmerman rotors and a brake flush with the proper fluid is all you need.
been looking at yellow stuff, as what I hear to be a great pad, and is more affordable than I imagined it would be.
I’ve dailied Redstuffs for 4 years now with no problem. They bite well, they don’t squeal, and they don’t make much dust.
No complaints about excessive dust, noise, or harshness - great pad upgrade with no glaring downside IMO.
I track the car and use the DS2500 pads with DOT 4 brake guild. Let me tell you this from personal experience, the stock pads fade real quick. After 2 sessions or so (15mins sessions), the brakes get real spongy.
I bought and installed EBC red stuff pads on my stoptech slotted rotors. I also have stainless steel brake lines too. I've had several techs tell me my brakes are fine, but I literally can push the brake pedal to the floor in some cases, including the highway. It stays like that for a while too as I'll be driving at 60+ mph, go to stop and it has a long bit of travel. I will even pump up the brake pedal while at red lights and stop signs just to get some more bite but I feel like I might fuck up the master cylinder doing this enough. The fluid was flushed less than 6 months ago, but I feel like I need to switch to a better pad if this is actually the issue. I felt like my ABS wasn't even going off at one point due to these pads, or that I had some trapped air in my lines.
Write your review
Help others - share your experience with this part.