Brake pads EBC or OEM BMW
I run EBC Redstuff pads, the brake dust is very minimal.
they held up fantastic. I drove to the track, and drive home after the track day; no issues.
Got a 22 brz and use ebc yellow the old formulation on a technical short track without issues.
I have ebc yellow in my c5 and very much prefer them over the hawk street 5.0 I had before. No issues with fade at any point.
I ran EBC yellows at PittRace on my Golf R and they held up fine.
EBC yellows are completely fine. I used them when I tracked my Gen coupe and never had an issue. Dusty as shit, but I liked em for the track.
I drove pretty damn hard all 3 sessions in the novice group passing all kind of faster cars that I didn’t expect to. I had minimal brake fade and a light pulsation developing later in the session after long straights but never came close to an “oh shit” moment. I was pleasantly surprised the next day when I inspected the brakes and found the pads around 2/32nds and the rotors well above minimum spec. I expected to go metal to metal before the end of the day.
I have ebc reds. I still get lots of brake dust and I prefer the bite of oem pads more. Not to say reds are bad, they just didn't meet my expectations for a daily.
But seriously, having owned several BMW's and Porsche products (equally bad for brake dust) I've just gotten used to cleaning wheels more often and ignoring dirty wheels when I don't have time or energy to clean them that day.
I bought and installed EBC red stuff pads on my stoptech slotted rotors. I also have stainless steel brake lines too. I've had several techs tell me my brakes are fine, but I literally can push the brake pedal to the floor in some cases, including the highway. It stays like that for a while too as I'll be driving at 60+ mph, go to stop and it has a long bit of travel. I will even pump up the brake pedal while at red lights and stop signs just to get some more bite but I feel like I might fuck up the master cylinder doing this enough. The fluid was flushed less than 6 months ago, but I feel like I need to switch to a better pad if this is actually the issue. I felt like my ABS wasn't even going off at one point due to these pads, or that I had some trapped air in my lines.
Write your review
Help others - share your experience with this part.