Brake pads EBC or Textar
Get OE blank rotors, a set of your preferred pads and some good high temp brake fluid. (I really like EBC yellow stuff for daily, autocross, and light track stuff.) Unless you're really going hard on the track, there's not a real need for slotted or drilled. Even when I did hard track stuff I still just rocked the blank rotors most of the time. They still held up well and were cheaper to replace too.
I went with EBC drilled and grooved with yellowstuff pads I think. Highly recommended
I’m rocking EBC RedStuff and I love them.
These are amazing pads - really big upgrade in stopping power. And as others mentioned, it’s per pair. So one of each. Tdotperformance is reliable, I use it specifically for pads and rotors for not just my vt but other cars I have worked on. Great service and vehicle confirmation.
The yellow stuff pads are also Canadian winter friend. They have similar biting power to the reds but better for cold bite. Only downfall with the yellows is brake dust is fairly high. My wheels get very dirty. High maintenance for cleanliness.
I have EBC slotted rotors and the green pads. Way better than stock. Will probably go with red when these wear down cause they claim to produce less dust.
I have about 45k miles on a set of EBC greenstuff and StopTech slotted rotors. I’m not hard on my brakes and my pad life is still good. Much lower dust than stock and roughly the same bite/engagement as stock. Maybe slightly more sensitive.
I just installed EBC Yellowstuff brake pads on my wife's 2021 Mazda3 turbo, made a huge difference.
I run EBC yellows on a heavy car (Kia Stinger GT) and they do ok. The problem with TNiA events (especially the novice group), there's usually A LOT of traffic, and no one is pushing the limit into braking zones.
I had EBC on my GT4, 10000 km and 3-4 track days and they were out.
I'm jumping in here on red stuff EBCs. They're good for initial bite but have awful brake fade on light applications and are noisy as hell. I've pulled the rears off twice to smear the backing plate in grease just to keep them quiet. Probably should've just replaced them entirely. Not worth.
Write your review
Help others - share your experience with this part.