Brake pads Mintex or Hawk Performance
I went with Hawk 5.0 pads and Zimmerman rotors on my 340i. Very happy with them.
I use Hawk 5.0 pads with R1 Concepts Drilled and Slotted rotors, stops on a dime and cuts alot of speed when adjusting going into corners very predictable
I run hawk 5.0 pads (i used to use ebc yellow but theres been reports of ebc pads delaminating so i stopped using ebc)
I use the centric premium coated blanks & change rotors every time I change pads.
For fluid I use ate200
I swapped out the hoses for braided ss hoses.
I currently use Hawk DTC60’s on my Scion FRS with Motul RBF600 fluid for track days. The brakes feel great to me, I like the bite, and they don’t fade even on multi day events.
Just switched to dba t2 w Hawk ceramics (combo set from new provisions racing) w factory calipers and lines.
I’d been considering brembo swap, but money had to be reallocated, so I abandoned full upgrade dreams. Old rotors were warped and pads were a dusty mess, so pretty much anything was an improvement.
Hawks are quiet, super-smooth/consistent engagement when I step on pedal, and minimal dust. Definitely happy w decision.
Adam's front and rear ventilated rotors. Mintex front and rear brake pads. Motul DOT 5.1 Synthetic brake fluid. Goodridge G - Stop stainless steel braided brake lines.
I run Hawk HPS 5.0 they are good but we're spongy even after the recommended break in. I ended up doing a run and intentionally abusing the brakes to get them good and hot to the point that they faded. After that, they were great.
I haven’t heard of fake brake pads but be careful. The main reason I’m commenting is HP+ pads might be good for autox but if you have experience on track, I’d avoid. Granted, my experience using them was on a 2015 WRX but you can overheat the pads pretty quickly on a heavy braking circuit.
As good as they are I had to stop using them because of the dust. Ruined the clear coat on my rims. Also the noise when coming to a gentle stop
My wheel looked the same after an autocross day with my 2017 Mustang GT. I was daily driving these pads a couple years ago, and they nearly destroyed my wheel finish when I left the dust on too long (not to mention how incredibly noisy they were). It took multiple washes with iron remover and the wheels off the car to properly clean it all off.
Write your review
Help others - share your experience with this part.