Engine oil Eneos or OEM BMW
As long as it’s a LL-01, you can put that in. I’m currently running that on my N52.
10w60 is the only oil you should put in these. If nothing else, you can usually find it at BMW automobile dealerships as that is what they put in the M3/4 series (or at least used to). Not cheap, but a lot less expensive than engine rebuilds.
A lot of people are essentially saying "don't beat on it until that gauge reads warm," which is incorrect. BMW, in the G series, switched to showing *coolant* temperature on the speedo and not oil temperature. That is NOT the oil temperature gauge, and oil takes a lot longer to heat up than coolant. When that gauge shows operating temperature, give the car another 10 minutes or so to get the *oil* up to temp.
Just drive it. With these 0w20 oil is circulated immediately. My G20 330e does a cold start when accelerating the highway. The RPM limit is protecting your engine so even with a kickdown it won't go above 4k RPM and will shift very early.
i drive a g21 330D xdrive, I've been researching warm up procedures and people recommend letting the oil circulate for 30+ seconds then cruising in eco pro as the torque band is toned down and it changes gears as early as possible.
Depend on the oil grade that is in the engine.
In proper units that’s -15°C which is very close to the limit of a 10W- oil. I would let such car warm for 5 minutes easily.
If your car is running a 5w or 0w it will be fine to start driving in less than a minute. Which is just the time you need to remove the snow and ice from the windows, how convenient :P
I do in my BMW. Oil is cheap compared to a re and re on a diesel no longer sold in country.
Eneos X Prime 0W-20
Nah you're fine. BMW engines are known for using some oil. Even 1l on 5k km is not much, even the dealership considers this as normal.
10k miles later, went to do my usual 1k mile quart of oil, looks like chocolate milk.
Write your review
Help others - share your experience with this part.