Engine oil VALVOLINE or Lucas
I've been running Valvoline for the moly content. Not burning oil yet, fingers crossed.
I'd recommend using some Valvoline for your oil changes from now on, particularly their Restore & Protect line. It shut those noisy lifters up in 2 oil changes on my old '09 Avalon, and good lord did it flush out a bunch of gunk I didn't know was in there. I got a few MPG's more after it was said and done, too, and she ran happy.
Use good oil, always helps. Try valvoline restore and Protect. Quieted my engine down a little
I used to use Rotella T4 as recommended by many on the forums. It was fine but I switched to Valvoline 20w50 because it has the additional Zinc like the Rotella T4, and a bit better film strength which protects bearings at high RPM.
I’ve had good luck running Valvoline VR-1 in engines with flat tappet cams.
Valvoline VR1 in whatever viscosity is suitable for the season and the VR1 has plenty of zinc for old engines.
If you’re burning any oil 20w-50 valvoline racing full synthetic. If everything is good and oil 10w30 full synthetic
that oil helped my Honda out tremendously with oil burning.
had a Y33 nissan with 305K miles on the OD, it was burning/losing about a quart every 900 miles or so, after 4 oil changes over a year and a half with Valvoline R&P, its now down to a quart every 3000 miles give or take a couple of hundred. its no more expensive than other quality oils so why not? if it can do that for a 26 year old nissan V8, it has me sold.
I run Lucas 5w40, it’s more about doing oil changes more often rather than anything else. VW doesn’t have any special materials in the block or heads, it’s just cast iron and aluminum no different than any other.
Write your review
Help others - share your experience with this part.