Spark plug Bosch or OEM BMW
Avoid the NGK’s Bosch or “Volvo” (also Bosch) plugs are way better than the NGK’s.
I had good luck with ngk bp6hs, Bosch w8Bc, champion l87yc and renault oem short thread (yes, really.) plugs. Bosch w8ac used to be good but i had some arrive not working out of the box recently so I'm now avoiding them.
the spark plug is less than 10k km old (bosch) so I initially did not change it. Decided to change it anyway to original mercedes (turns out made my NGK) bam emission passed, LTFT now hovers at 5-8%.
I've changed my spark plugs three times, always with the Bosch Iridium, never had any problems. Pre-gapped, takes me about 30 minutes from start to finish. Lasts me about 90,000 miles.
The new ignition switch is in. The spark plug wires are Bosch copper and now have the Bosch super 3 ground electrode plugs installed. So with a fresh ignition switch that eliminated the odd electrical changes we were seeing in the dash lights, now stronger cranking and it does run better.
I just completed my first spark plug change on my G20 330 at 40k miles. Three of them especially Cylinder 1 came out "wet" and I'm unsure if it's oil.
I'm still not entirely convinced that it is weak or under ignition versus over fueling. Either way it just seems like it's having a hard time burning the fuel that it is getting. I still can't help but wonder about the Bosch Platinum 2s. I have had good luck with them before my Mark 2 GTI and the car did run well with them for a good 10 days before all of this started.
My 2000 with California emissions (regular cat and then two pre-Cats at the exhaust headers) would only run properly with the oem spec NGKs. Threw Bosch in their once and it ran terribly.
Ever since Bosch moved spark plug production to Russia, the quality has been sketchy.
I replaced my sparkplugs, and everything went smoothly except for the front plug on the driver's side. All the other spark plugs screwed in with little to no need for a socket wrench - except for tightening at the end.
This one plug seems to be stuck halfway down the middle of the thread and won't go deeper unless I really torque it. When I took the new spark plug out, I noticed that the tip was bent with the spark gap being much smaller than the other new piece.
Write your review
Help others - share your experience with this part.