Brake pads ATE or Centric
I went with the centric posi-quiets on my GLI. They are everything I hoped for. PS. the clips are a pain but I found a little deadblow hammer to the top of the pad and they popped right in.
After some miles on the car no dust! Approved!
I just replaced my brakes few weeks ago. I did TONS of research and the best combo I feel was Centric Premium rotors and Centric Posi-Quiet Ceramic pads. Get from Rockauto and google 5% off coupon. I am super happy with them and no squealing at all. Just came back from a 1500 mile road trip with no issues.
I got them installed and the hardest part was the dam clips they are so hard to compress to slide them in. I had to juggle them sideways. Anyone had this problem? I needed a second hand. They feel great! They are so much thicker than stock. I fallowed this guy's video: Yes I had to compress the Pistons.
The Centric PosiQuiet ceramics are WAY better than the OEM pads, no nasty hard-to-modulate initial bite. Rather the Centric's are quite linear in their force-to-braking ratio. I just upgraded my '18 GTI to a '19 R and have a set on order.
I went with the Centric PosiQuiet Ceramic's too and am very happy with them Akebono does not have an application for my 2018 GTI SE but the PosiQuiet's feel the same to me as the Akebono's I had on my last two Audis.
I'm running Redstuff as well - they are OEM compatible.
Continuing to drive on them this way will not make the pad deposits go away. Trust me. I have the same ceramic pads on our 3 vehicles (golf r included). Centric posi quiets. They are great pads with great cold bite and minimal dust. But if you overheat them and stay on the brake pedal at a stop, like any other pad, it will embed pad material onto the rotor.
I don't believe you lose cold temperature bite with good OEM replacement ceramic pads like from ATE.
I have just put posi-quiets on my PP GTI and I'm experiencing vibration while driving at highway speed (68-80 mph, worst at 75ish). Re-checked torques and the faces of hubs/wheels were clean. Will go in for a balance but is it possible I got a **** rotor or something? Possible I have a bent hub and didn't realize it until the rotors were swapped?
Write your review
Help others - share your experience with this part.