Brake pads ATE or Hawk Performance
Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.
Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.
Hawk hps 5.0 and blank Zimmerman rotors
stick with ATE or akebono. both good for their price. have ran both on my e39 and they work great with their respective rotors
FWIW I wound up with those Brembo front and Zimmerman coated rears with ATE ceramic pads and I’m very happy with it. To me the stock setup is grabby at low speeds and these are much smoother. I don’t feel like I’ve lost any stopping power. Huge difference in brake dust.
I literally just did exactly this.. Had the BRAKE warning light on the dash and replace rear brakes on Idrive message on my 2019 X3 M40i at 32k miles.. rear rotors looked fine to me.. they were smooth and not grooved.. so i bought OEM ATE PADS and a BOWA rear brake sensor.. $128 shipped from Pelican parts and i was charged 1 hour of labor ($135) at my local Indy shop.. as others have mentioned youtube is your friend.. just a rear pads replacement is a pretty easy job w basic tools.. I should have done it myself but I decided the $135 cost was not worth my time and effort.
Whole setup feels really damn good.
I haven’t heard of fake brake pads but be careful. The main reason I’m commenting is HP+ pads might be good for autox but if you have experience on track, I’d avoid. Granted, my experience using them was on a 2015 WRX but you can overheat the pads pretty quickly on a heavy braking circuit.
They feel amazing and the braking power is noticeably increased but they create an incredible amount of corrosive dust and make a really terrible high pitched noise on occasion under light braking.
Should’ve gone with EBC! Tried Hawk hps blues and could not go more than 500 miles before taking them off and replacing them with EBC yellows again. The noise was horrible.
Write your review
Help others - share your experience with this part.