I put ATE200 + Ferodo DS2500 pads on my Mk7 in prep for its one (half) trackday, have been on for a few thousand street miles and work well at all temps.
I'm really liking the ATE pads I got for my 340i with the brembo F/Rs.
I went with the pads from ATE and got them fitted today, all in all it cost around 200 USD / 2000 SEK. 2 years ago the mechanic told me all 4 brakes need replacing. Today when they were replaced the rear ones had about half of the material left and the front 1/3.
I went ATE pads and rotors from FCP and couldn't be happier
I run ATE Ceramic pads with Zimmerman rotors on my MK7 and am very satisfied.
I put ATE on my 335is a year ago and am very happy with them. Almost no dust and good stopping power. When they were new, the initial bite was a bit weak, but that went away after break in.
For normal use, I recommend ceramic pads like ATE Ceramic, EBC green/red stuff or TRW D-TEC, since they're lower dust, and lower heat. Otherwise, go with Ferodo Premier eco friciton.
ATE Ceramic pads and ATE disks are my go to because they are OEM, but a little extra performance on top. Zero complaints at all from me and they are quite reasonable price wise too
I have run Wilwoods on my Corrado for years with the usual rebuilding every two years. Even with ABS under full braking using the BP10 pads it would occasionally lock up fully and blow a cogged belt off the supercharger.
I don't know much about Stop-Tech, however, I have heard from a friend that used Wilwood that these perform best in non-Winter driving conditions. He said that over time they will not stand up as well as a Brembo set up. It might be worth noting what climate (Alaska vs California) that you spend most of your driving time in as well when factoring a BBK upgrade. I also noticed that you are quite new to this group so allow me to introduce you to the member who will derail all original posts into something else to the point where your thread may get locked up. See below. GoGo Golf R said: Ok let's try to agree on the following: 1) Upgrading the brakes is mostly justified for track driving purposes No, Personal preference. 2) Changing the brake pads will reduce dust for street driving Depends on your pad choice 3) Changing the brake pads, rotors and brake lines is pricy Subjective 4) The OEM brakes, while not totally ideal for every driving style, will suffice for average street drivers and some track drivers Depends on your driving style 5) Downshifting with correct rev-matching, will extend the duration and reduce wear on the brakes Yes because replacing your clutch is much cheaper than new pads :screwy:
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
