I use (and like) ATE type 200 fluid and Hawk HPS or Ferodo DS2500 pads, for autox.
brakes i would go with Zimmerman, ATE or Brembo rotors. now for pads go with Hawk HPS 5.0. the just very little and STOP. Plus they are easy on rotors. i know because i have them.
Brakes were great, no fade issues(Hawk Ceramic 5.0 pads up front, stockers in the rear) running Motul RBF. Mixed conditions so I had a little of everything, rain, drying, damp. NO bias problems at all, no issues w/the ABS doing funky things. The car didn't want to throw itself off track or anything like that, even in the rain. Just very progressive feel. They put up with me having to trailbrake the crap out of this car so I figure they did ok.
Front Golf R OEM Brakes include: TyrolSport Stainless Steel brake lines TyrolSport Caliper Stiffener kit (re-lubed every year - had them on for 4 years, re-lubed 3 Times, so good condition) Hawk HPS pads The above parts were installed at about the 24k mile point, so have about 24k miles on them.
I replaced REAR pads and rotors myself at the end of June of 2017 when I was at 54,000 miles. I used Bendix Ceramic Pads / D1348: https://www.carid.com/bendix/cq-ceramic-rear-disc-brake-pads-mpn-d1348.html These should fit your CC as well (they fit 2.0T and VR6 )They run very clean - like no dust, like the original factory pads did (maybe cleaner). I also opted for oem style rear rotors. Nothing fancy, no slots or drilled holes. The originals didn't have these features and I found them totally serviceable without them. If you buy aftermarket standard style rotors, just be sure that they match the specs of the original factory ones. For my car, the VR6 has rear vented rotors (the 2.0T has solid unvented). I confirmed the vane count and the rotor thickness matched the originals when they were new and then made a decision. I think the rotors I got online were duralast? I can't quite recall. Anyhow, I'm sure I'll be shamed for not going to the VW parts counter for VAG branded parts. But with that said, I have over 2500 miles on since then and the car stops beautifully with zero pedal pulsation. All-in, with a tube of compatible brake grease, I think I was at about $115 in parts and 2.5 hours of my labor.
Love the pads, don't like the squealing at times, but for a high torque pad it's really good. They have the same feeling at Hawk DTC's which I use on track, but have that strong bite at a MUCH lower temp. than the DTC's do.
I just replaced my OEM pads with Hawk HPS5.0 pads and slotted StopTech rotors. Slightly more dust than the OEM ceramic pads but they do a good job.
i'm using hawk pads (on my second set) currently, but might try the reds on my next swap out.
I have hawk HPS on mine. Dust wise they arent too bad. But I wouldnt mind something cleaner. They do the same thing and hang over the inner edge a bit.
I am always happy using the cheapest ceramic pads I can find and the cheapest rotors I can find, no matter what car its going on. I have expensive Hawk Performance Ceramic on my STI and they're actually worse than the cheap stuff. Tons of dust and even some noise.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
