Brake pads Bosch or Hawk Performance
Just replaced all four brake pads and rotors on my 2018 MZ3 hatch with 46,000 miles. Used Bosch quiet cast brake pads and rotors. Paid around $350 for parts and took me around three hours.
I’m a fan of the Hawk HP+ track pads! The bite and fade resistance is excellent. They’re a little squeaky on the street but not terrible.
For last Autox season I used the factory calipers. Hawk blue pads, motul brake fluid. Had no issues at all.
I change brakes at least yearly, sometimes more often if I'm driving in mountainous areas alot. I always buy the Bosch ceramic brakes and just buy the low cost rotors because I change them at every brake change (cheaper than having them turned in Phoenix). I buy everything off Amazon. A four wheel brake job will cost me less and $100. 2019 LE.
I've been using the Bosch QuietCast ceramic brakes in the past and have zero complaints so I think I'll go with these: BOSCH BC1212 QuietCast; Ceramic - Rear ($26.79) BOSCH BC2076 QuietCast; Ceramic - Front ($37.79) I'm looking for high quality/high value. I don't need "high performance", I'm not doing any track stuff, just basic commuting but would like longevity, value, performance, etc. I ended up getting: POWER STOP JBR1763SCR (Daily Driver) Semi-Coated - Front BOSCH BC2076 (Premium) QuietCast; Ceramic POWER STOP JBR1764SCR (Daily Driver) Semi-Coated - Rear BOSCH BC1212 (Premium) QuietCast; Ceramic It was around 260 dollars with tax and shipping.
I autocross a bit and went with Hawk rotors and pads from Tirerack after a bit of mulling it over. Overall fairly happy with them, a little dusty but have NEVER faded while on them hard. Put maybe a hard 5k miles on them so far.
edit- I do have a 1.8 and as mentioned at least once you should consider getting the 1.8's calipers.
I run hawk hps pads on my NA. They've held up to entry level track work and not made much noise on the street. Feel fine when I choose to drive the Miata to work.
Just switched from Stoptech street pads + stoptech drilled and slotted rotors to zimmerman cross drilled rotors with hawk hps5.0 pads. Must say I like my Zimmerman + Hawk setup a lot.
I used these Hawk brake pads for a HPDE track day so they did get very hot. They still have 10mm of thickness left, but this particular pad has these very pronounced cracks. All other pads have very minor cracks (barely visible), but this one was the worst.
Not only do they do that, they're a terrible autocross pad. Dust is something that happens with pads that stop there are very few that stop and don't make dust. However there are different types of dust, stuff that sticks to everything and stuff that wipes off easily. But the problem with those pads in general isn't even the dust it's there very on off switch nature. They're very powerful and they're very grabby and they do not release well either which makes abs fight a lot more to do its job.
Write your review
Help others - share your experience with this part.