So far I've been happy with Bosch brake pads.
Bosch Quietcast pads. They have good stopping power, are quiet (so far) and have low dust, so they are great for my daily driver.
I used rockauto and got.
BOSCH BC433 ceramic Brake Pads on my front brakes.
They have been real good.
I also have those Bosch pads on my Tundra and they are really good, quiet, low dust, excellent overall.
I think the Bosch pads work fine.
Last year a shop replaced the rear brake pads and disks but since then handbrake never was like before. They kept telling me it will get better which I believed at the time but it never did. Last month I've passed inspection and they told me that the rear left handbrake was almost out of spec and I'd need to check it out although it passed.
So a month later I've bought a Bosch kit, sliders, pads, grease, toolkit etc and replaced the 1 year old ferodo pads. Now handbrake is like it should be and I'm happy with it but take a look at the old pads...
Both inner side alignment pins (caliper side) are bent.
If the price is right - yeah, but there are better alternatives than BOSCH, for a little bit more. I installed brakes front and rear, new pads, rotors etc ~9-10months ago, they squealed like a pig for 5-6 of them, and I drive quite a lot, not just short commutes to the shop and back. They have been properly broken into, did everything to spec, bought genuine parts, not a knockoff, squealing like mofo. At the same time, I did brakes on my dads car, diferent brand, and price was ~1 euro more. 0 squealing from day 1, even during break in period. Before they were really good, now - not so much. They work, and they will do the job fine, however there are better brands, that offer value for the price you pay. I avoid batteries made by them, because they like to go bad after warranty.
I replaced front pads and rotors on my Tiguan, and afterwards, when going between D <-> R and applying the brakes, the first brake application causes a "clack" on both sides at the front. Pads are Bosch 1633A. spring clips (integral to pads) are seated properly. Pads and rotors were bedded properly. Wheel lug bolts torqued properly. I have the official instructions from VW. I've probably done ~20 brake jobs in my life, mostly Volvos (over half of those were sliding-caliper designs like the Tiguan's). What I tried (with no success): searching and searching and searching forums, only found 2 other people with a similar issue on FCP's Brake Replacement YouTube video measured and compared all latereral dimensions of the pad's plate between new and old, same dimensions re-installed the pads all bolts are torqued properly (caliper carrier 200 Nm; caliper pin bolts 35 Nm) found a Tech Bulletin from VW that mentions there are inner- and outer-specific orientation for the pads. This appears to apply only to the Genuine (labeled TRW) pads, as all 3 Bosch pads are identical in every way that I can discern bought a set of Genuine VW pads (labeled VW), ensured the correct orientation of pads according to the Tech Bulletin, and they still clack. pad backing plate dimensions are the same as the Bosch. Ack! More money! bought a set of genuine caliper carriers (with the thinking that perhaps when I wire-wheeled the old caliper carriers to remove rust, it took off too much material). I didn't install them because I measured all the dimensions that interface with the pads and the new are identical to the old.
Replaced front and rear pads with Bosch quietcast ceramic pads. Greased the back of the pads and slides. Pads squeak obnoxiously when cold. So when I roll out of my driveway and brake it’s loud. Then down the street I brake and it’s loud. But once I get rolling onto the main road and they warm up it makes no noise.
I just replaced the pads (Bosch BE1633H) and rotors (Textar 5Q0615301G) on my MK7 R, and after torqueing everything I noticed a clunk when rolling up and down my driveway (happened only when going from forward to reverse or vice versa). I jacked the car up, took the wheels off, and checked all the bolts, everything was tight and torqued to spec. I then noticed that the brake pad itself is shifting.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
