Brake pads EBC or Akebono
Bought Akebono pads from Tire Rack...Took a test drive, and found the results to be excellent. Felt great, super quiet. The Akebono pads do not require any bed-in, so just drive off normally
Akebono pads and brembo rotors avail at fcp/ecs - best combination I’ve had so far and I’ve tried textar, pagid and trw, (trw is a close second but more dust than akebono)
For daily driving, EBC Redstuff are perfectly capable and inexpensive.
Last year I switched to the EBC Redstuffs. Overall braking power hasn't necessarily improved that much (according to the butt dyno), but appears to handle heat better as my brake pedal stays consistent through the entire day and doesn't begin to feel softer during the end of the day during my last couple runs.
I run EBC greens. Really nice bite, cold or hot, stock quiet, and a little less dusty than the yellows.
I use EBC Yellows for my STR NC and like them a lot.
I recommend ebc blues to everyone and always get positive feedback, they bite better than oem cold and way better warm they are very dusty though.
EBC yellows have been great for me. Minimal squeal and moderate dust I also tried a set of OEM style ceramic pads but faded them on a high speed autox course.
Akebono ASP1347 rear, ASP1346 front. Ceramic pads for the sport package brake system. They uhh, like to sing when wet though.
I bought and installed EBC red stuff pads on my stoptech slotted rotors. I also have stainless steel brake lines too. I've had several techs tell me my brakes are fine, but I literally can push the brake pedal to the floor in some cases, including the highway. It stays like that for a while too as I'll be driving at 60+ mph, go to stop and it has a long bit of travel. I will even pump up the brake pedal while at red lights and stop signs just to get some more bite but I feel like I might fuck up the master cylinder doing this enough. The fluid was flushed less than 6 months ago, but I feel like I need to switch to a better pad if this is actually the issue. I felt like my ABS wasn't even going off at one point due to these pads, or that I had some trapped air in my lines.
Write your review
Help others - share your experience with this part.