Brake pads EBC or Ferodo
I love the EBC RP-X, fantastic pads. I use those up front and the Bluestuff NDX compound out back. Great HPDE setup on my ~400hp/3350 pound station wagon.
I have them on a 1600lb race car, so maybe not comparable to a Camaro that weighs twice as much. They're almost too much braking for me, but I kinda prefer it that way. I can lock the slicks at 100mph without fully standing on the pedal. But they're also very easy to modulate. They don't need to be bedded in like normal pads; you just stab them a few times. They don't fade. I've only had them for 1 season, but there's hardly any wear. It looks like they might last me 3 seasons, maybe more.
I've ran 2 seasons in a 3300lb Golf R with SR21 fronts and SR11 rears and they've been insane, in my humble opinion. One front set lasted 10+ events, with street miles in-between, and the rears are still the same originals I slapped in 2 years ago. Zero fade, crazy long life, and no chunking/glazing/side effects I can think of. Ran DTCs in the past, and I'd snag these in a heartbeat over any other pad I've used or seen firsthand. The only complaints I have is they bite HARD. Since these work from ambient they will throw you through the dash in the paddock if you aren't careful ???? The plus to that is no real warm-up laps needed. Sintered also stands up to heat extremely well since there is no resin to break-down, which means I can run titanium shims without it baking the pads. Outside that, they throw off some weird non-ferrous silvery dust. Nothing like most race pads where it'll cake everything in the wheel well. It's almost like a bit of gravel dust after every event. Then the price, depending on your pad shape. They're a little under $100 more than most pads in my case, but the life of them more than makes up for it.
I used EBC blue stuff on my BRZ with factory brembos, and replaced the pads using FCP euro lifetime warranty. EBC blues would hold up for multiple track days with stock power on 200TW tires, and I didn’t experience fade at my skill level, usually intermediate at HDPE days.
I have a dedicated track car but I use it to have fun. Therefore, I'm going to test out EBC Bluestuff NDX pads to start this season. I've also used PowerStop Track Day pads and they felt great.
I did dot 4 fluid, braided lines, new solid rotors, and EBC yellows and couldn’t be happier. Brake fade was VERY much improved.
I've used EBC Yellowstuff and Intima race/track pads for the i30N from Australia...both were fine, but I liked the factory Hyundai pads better.
I like the EBC SR11 but a little noisy at lower speeds & temps.
I burned EBC Blues up in a single day, decided they weren't up to it.
I recently purchased EBC BSD rotors and EBC RedStuff. The front rotors ended up with an unknown lead time, so the rep reached out and suggested DBA 4000 T3s. I dropped the car off at the dealership as they'd agreed to cover the labor under warranty. I stopped by yesterday and was told they were having some issues with the install and that the pads didn't come with hardware... the tech was already left for the day I swung by again today. I was told that the holes in the pads were slightly larger than the pins, which allows for the pads to shift up and down. I took it home and confirmed everything is good in one direction, but when I pop it in reverse and hit the brakes, I hear a metal to metal click as the pads shift up and hit the caliper. The same is true when I put it back in drive and hit the brakes.
Write your review
Help others - share your experience with this part.