Brake pads EBC or OEM BMW
EBC red stuff or Hawk HPS 5.0 pads. Both are better performing than stock and create less dust.
On the 63S I spend 150 each Brembo rotor and 180$ EBC redstuff pads, hardware 10$, sensor 8$. These things are silly easy to do on the rear.
I have put 10k miles on it since then. The car has given me no issues whatsoever other than changing the brake pads and sensors.
I have Speigler stainless lines, EBC pads, and Motion 5.1 fluid in mine.
Best things I did for my g80 was 1) Mishimoto skid plate to protect my oil cooler 2)Ceramic brake pads because the red dust that will engulf the lower half of your car after a 1/2 mile drive is insane.
Get the EBC RedStuff kit from FCP. I've had them on several cars and it's exactly what you describe. They held up to some AutoCross as well.
And even the normal things they need are a little pricier than on normal cars; you might need ($300) brake pads and ($1,000) brake rotors in 50,000 or 60,000 miles instead of just ($250) brake pads.
Configuring new car I would definitelly go for ccbs. The braking power is massive. But if driving in cold weather, snow or cold rain and not touching the brake for couple of minutes on highway and the first braking after that is basically no braking.
If used incorrectly on the track you can fuck them up. Dont ask how I learned that. Swapping them to steelies now. Car is at 130k kms. The weight of ccbs is good but they starting peeling probably due to overheating them with too much worn brake pads.
Good to know EBC quality control still sucks. I had a pair of their pads come apart, literally the meat of the friction material sheared off the backing plate.
I wouldn\u2019t get them again. Occasionally noisy at low speed, very unsettling brake feel in heavy rain/water, debris can get trapped between the caliber and wheel creating an ungodly noise. That being said, I have 82k miles on mine and still original pads.
Write your review
Help others - share your experience with this part.