I have some lighter rear rotors that are OEM sized saved 5lbs along with stainless brake lines and the brake master cylinder brace that keeps it from flexing on firewall...all from ECS to be paired with EBC reds up front and blues in the rear. IMO it was the quickest way to liven up braking capability without getting into big brake kits.
I mean I hit 90k miles before I needed pads on a chevy colorado so...
I have a 13 year old Chevy Volt with 173,000 miles still on its original brakes.
Listen, try to change your brake pads and just to be sure, fill a new brake fluid and the problem likely will go away. But try pads first. I recommend using EBC DOUBLE H sintered pads
I did several track days last year in my 2016 GTI with EBC blue stuff pads front and back. Really liked them. Stayed good for 20 and 30min sessions. Used fresh motul rbf600 fluid.
So, I run EBC yellow stuff, and they're honestly pretty fantastic street pads that will tolerate the use of light duty track days and autocross. I've ran them on multiple vehicles because they have a nice cold bite while still being able to cope with higher temps and having a good feel in modulation. Though, I've decided to for this season move to the blue stuff pads for one of the toys seeing track time this year. Do be warned, the Yellowstuff pads can be rather dusty.
I’ve been a big fan of every EBC pad I’ve used. I liked yellowstuff but not when it’s winter. When they are hot they are incomparable to anything else I’ve used (I have used very few different pads so this isn’t a real data point). I like greenstuff for anything but driving at 9/10ths or above. They tend to fade quickly. I’m running Redstuff pads now and they seem good but I haven’t pushed them. They have a little more overhead than greenstuff apparently. They work well at low temperatures.
Have had EBC Red stuff, Yellow stuff and Blue stuff. My impressions of them are below:
Red stuff - slightly better initial bite than an OEM pad, the same goes for performance at higher temps, however on track they didn’t last more than a couple of laps. Certainly more of a daily/fast road pad.
Yellow stuff - initial bite ever so slightly lesser than the red stuff, probably inline with OEM. However they put up with more abuse at higher temps and rarely gave much brake fade. Bit dustier, would say fast road/occasional track pad.
Blue stuff - initial bite worse than OEM, after a few hard stomps you can feel them waking up. Stand up to track abuse very well. After multiple fast laps on track, I felt it was the discs that were getting too hot, so these pads highlighted I needed brake cooling to keep going. Squeak at low speeds, dusty.
To answer your question, imo there isn’t a situation where blues are more ‘streetable’ than reds, I’d swap them out for reds and if you can, keep blues for the track ????
HTH
EBC's suck so it's nice they provide a chart with better pad options :)
I've used Yellow Stuff about 4 times on 4 different cars. I drive very aggressively on the street during midnight haulin ass events. First off, even on the street I glazed them on all 4 cars. The one car I fried them in one night, and they cooked my rotors too.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
