The stock pads that came on my RS3 were god awful for brake dust. After 2 days of normal highway driving they looked like crap. They also hit the wear sensor after only 15k miles which is bananas for a mostly highway driven car. I bought a set with a new pair of 2 piece rotors and the difference is night and day. Braking is much stronger and zero fade even in more demanding conditions (the two piece rotors obviously help with that) I’ve had them on for 25k miles and they have very little wear on them. I’d definitely buy them again. That said, be warned that for like 500-1000 miles after they are installed, your wheels will be the dustiest you’ve ever seen. Once that wears off, they run very clean.
Just did EBC Redstuff and EBC USR slotted rotors on my GTI and they have been great.
They’ve been installed for a few months now and they’ve been great!
I ran a set of EBC Greenstuff 2000 Series pads over EBC slotted and drilled rotor on my Ford Focus. Quality difference over OEM is huge. I'd never run OEM again.
On my Mini SE, I have EBC red on the front, yellow on the rear to add more rear brake bias. Works great for DD and AX. On my R53 with correct brake bias, reds all round. I really like the reds for both DD and fun driving.
For daily driving, EBC Redstuff are perfectly capable and inexpensive.
Last year I switched to the EBC Redstuffs. Overall braking power hasn't necessarily improved that much (according to the butt dyno), but appears to handle heat better as my brake pedal stays consistent through the entire day and doesn't begin to feel softer during the end of the day during my last couple runs.
I recently installed EBC redstuff with new rotors. Did the bed in procedure and worked great for first 300 miles or so. Today, I noticed a really loud squeaking noise coming from one of my wheels. Noise starts after brakes are warmed up, and increases when turning the wheel. Goes away when I apply the brakes. Think my pads might be glazed after some sprites driving, but not like I’ve done anything crazy.
ebc yellow are G A R B A G E
I bought and installed EBC red stuff pads on my stoptech slotted rotors. I also have stainless steel brake lines too. I've had several techs tell me my brakes are fine, but I literally can push the brake pedal to the floor in some cases, including the highway. It stays like that for a while too as I'll be driving at 60+ mph, go to stop and it has a long bit of travel. I will even pump up the brake pedal while at red lights and stop signs just to get some more bite but I feel like I might fuck up the master cylinder doing this enough. The fluid was flushed less than 6 months ago, but I feel like I need to switch to a better pad if this is actually the issue. I felt like my ABS wasn't even going off at one point due to these pads, or that I had some trapped air in my lines.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake discs FEBI got the first review!
The power steering pump OEM Volvo got the first review!
The brake pads OEM Infiniti got the first review!
In the rating best shock absorbers already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best windshield already 14 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating battery for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
For headlights OEM Volkswagen already 50 reviews.
For brake caliper OEM Volkswagen already 25 reviews.
For tires GISLAVED already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
