For track purposes, I upgraded my rotors to stoptech slotted, pads to ferodo 2500, steel lines, and rbf600 fluid. Gets the job done, and stays consistent over the course of a typical track day. The braking power/feel is not much greater over the stock rotor/pads combo, but holds up better to the heat (those OEM pads do like to melt, if abused).
I also run Motul RBF600 fluid and Ferodo DS2500. I use my R as DD (~13K miles/year) and about 10 track days per year. Setup is fine for both and I recommend it as a good setup for your situation.
I typically run RBF600 with Ferodo DS2500, changed at the beginning of spring and after each HPDE (back to OEM brake fluid in the winter). Massive improvement over the stock for sure, but at the end of a 2 day track weekend the pedal will be on the softer side, which improves after brake flush.
I have had good success with Ferodo DS2500 pads front and rear, OEM rotors, and RBF600 (or equivalent) brake fluid. The Ferodo pads were fine to use for the street (no noise, normal dust, and seem reasonably rotor friendly) and competent on the track.
Hawk hps brake pads, best bang for buck, imo. I would replace the rotors if they are starting to develop a lip at the edge of the rotor. So by looking or feeling the rotor when it’s cold or you haven’t driven it for a while. Again test when cold, never hot. If they do need replacing you can check out ECS tuning and they usually have a brake pad + brake rotor combo deal, I believe it’s under their maintenance or performance section on their page, also filter out using your car make and model. If you’re strap on cash then you can check out Chris fix on YouTube and he has plenty of DIY videos on how to install. Good luck! I bought the drilled slotted and hawk pads combo from ecs and have them on my car now. Definitely improves the brake pedal feel tremendously, would recommend.
Hawk HPS Pads
Hawk HPS 5.0 Pads + Stoptech cryo-treated rotors - done as part of a total brake rebuild; slightly more bitey than stock, just how I like it.
At ~94k on ours now...we've replaced all brake pads (hawk 5.0)...
They are absolutely not track pads. They fill this awkward in-between in which they have the coefficient of friction and modulation of good aggressive street pads but also dust and make tons of noise in street usage.
The M240i needed new pads and rotors. I order HPS 5.0 + Zimmerman rotors from FCP's site which says they're compatible. I install them and the car sounds like a jalopy. Loud wub wub wub under braking and only braking, more pressure == more loud. It sounds like it's coming from both fronts.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake discs FEBI got the first review!
The power steering pump OEM Volvo got the first review!
The brake pads OEM Infiniti got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
In the rating best fuel pump already 5 brands participate!
In the rating best windshield already 14 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating brake discs for Volkswagen Golf already 5 brands participate!
In the auto rating tires for Ford Mustang already 5 brands participate!
In the auto rating shock absorbers for Ford Ranger already 5 brands participate!
For starter motor OEM Volkswagen already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
