Brake pads Hawk Performance or OEM KIA
Running Hawk DTC 30s on a Mustang (3800 lbs with me) both front and rear. I brake hard and the car is heavy. The pads don't glaze nor fade. Wear is OK.
I daily DTC-60s and they're surprisingly not that noisy.
I am stock turbo FBO (engine wise) FiST, switched from Powerstop Trac Day Spec to Hawk DTC-60 with good results.
I’m a big fan of how my brakes feel after upgrading to the Hawk HPS 5.0 pads, Bosch solid rotors (drilled/slotted do more harm than good), and some Goodrich Stainless Braided Brake lines.
Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.
Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.
Hawk hps 5.0 and blank Zimmerman rotors
I run Hawk HPS 5.0 they are good but we're spongy even after the recommended break in. I ended up doing a run and intentionally abusing the brakes to get them good and hot to the point that they faded. After that, they were great.
I haven’t heard of fake brake pads but be careful. The main reason I’m commenting is HP+ pads might be good for autox but if you have experience on track, I’d avoid. Granted, my experience using them was on a 2015 WRX but you can overheat the pads pretty quickly on a heavy braking circuit.
I did two track days on these new hawk hp+ brake pads and Zimmerman rotors. After the first track day, something weird started happening: I started hearing the squealing that I hear while breaking even when I’m not breaking. It’s not constant, but it’s coming from all four wheels and is mostly heard at low speeds, especially after starting to drive after coming to a complete stop. These are two track days in. Should I be worried?
Write your review
Help others - share your experience with this part.