Brake pads JURID or DIXCEL
For pads I've used Jurid White successfully in the past, they produce a lot less dust than the OE.
personally i run dixcel z-type pads and a stock rotor with DOT4 fluid and its one of the best upgrade options IMO
These are the best double duty brake pad I have tested so far. I have tried stoptech 309 and EBC blue ndx which will start to fade around 4-5 laps at my local track. The dixcel pads I can not get them to fade at all. Pad life seems okay with mix use but street manners are abit worst than the stoptech and EBC (sometimes squeals and dust alot).
Buy pads and the sensor from FCP Euro. Use their lifetime replacement warranty for the next set. Went to the dealer in July for an alignment and they recommended pads for a similar price. I bought pads rotors and sensors for front and back, total was $1000 for BMW parts. You could save with Jurid which is listed as OE and OEM. My pads are at 4mm all around so I'm actually waiting for the sensor to trip before doing the job.
For brakes, you're limited to whatever you can fit with your wheels.. I doubt you'd fit Brembo's with them, so you may be limited to 4pot/2pot or just rebuilding your current calipers with good street pads and rotors.
On my WRX, I use Dixcel ES pads front and rear
Upgraded rotors (paragon 2 piece) and dixcel type z pads.
Dixcel m pads good stopping and ultra low dust.
The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.
had a track day over the weekend and saw that a hard, black substance that seems a little rubbery had formed on the brakes. The brake pads are Dixcel ES brake pads. I had not bedded them in and instead street drove with it for a couple months as the website suggested. Brake grease was placed on the pad surface contacting caliper. The track has lots of left turns and I braked from 170+ kmh to 80kmh on the first corner. I'm pretty new so i may have braked deep as I was turning. The substance formed heavily on right front wheel, less on left front and none on rear. Brakes were smoking lightly when i came into the pits. Braking feel didn't change throughout the day as I continued lapping. Car still tracked straight. I tried not to brake too hard and didn't observe any other substance buildup.
In hindsight, however, I do drive 15 miles up/down/through a mountain pass 5 days a week. That’s gotta be the culprit!
Write your review
Help others - share your experience with this part.