Brake pads OEM Audi or OEM Volkswagen
Over the weekend I finally got the brakes to cooperate, so it's just about time to get a few test runs in.
I did our Atlas rear brakes without a scan tool.
I have done the all the brakes on our 19 Atlas myself. Like previously stated fronts are straight forward and easy.
No, no scan tool is needed at all for the fronts. They are basically the same as any other brake job. I actually found them easier than my other vehicles
They handle brake fade quite well. Did a run down tail of the dragon and had no issues.
1.5 years ago a client was offered brake pads only with a 1 year warranty, no guarantee against noises or pulsations, or brake pads and rotors together with a 3 year warranty against noises and pulsations. They opted for the 1 year option on their fancy 2017 Audi because the rotors were stupid expensive.
The only other good thing from this visit is that they measured the brake pad thickness which confirmed that I need to replace the pads soon. We are currently at 59k and the rears are in the red at 3mm while the front was at 5mm.
Secondly, defective Rear Disk Brake Pads that wore out on a majority of 22` Taos which was a covered rear Brake replacement if it was under 2ydears and 24 months. I just missed the cut-off and was$700 poorer.
My front brake rotors warped at ~12K miles. I had them machined and they lasted about another 12k until I replaced them with aftermarket Centric. Those lasted ~12K miles until they warped. At this time I went back to VW OEM rotors and they lasted ~12k miles. I had the OEM's machined, but now they are warped again. Along the way I tried some aftermarket pads, and generally had problems I purchased a pair at NAPA and they were sloppy in the caliper and would shift and click when applying the brakes in reverse. Went back to OEM on the pads and have no problems.
I have 4,800 miles on a 2023 MK8 and my brake pads are sticking to the rotors.
Write your review
Help others - share your experience with this part.