Brake pads OEM Mazda or Hawk Performance
At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.
Hawk Street 5.0 have been better at stopping than stock, lasted over 25k miles with about 60% left, and have dramatically less dusting than stock.
I run stop tech rotors/hawk HP plus pads/motul high temp/and goodrich SS lines on my m coupe and that’s also a great, much less expensive set up.
refresh brakes with Hawk HPS 5.0 and restore look of the calipers
I replaced my OEMs with Hawk HPS 5.0s. Very similar feel to the stock pads without that initial hard bite. Less dust as well.
I upgraded to motul 600 and hawk hp+ for my first track day. Both held up very well for my first day. I plan to use better pads next time though for similar reasons, the hp+ will overheat but they are gonna be better than stock. There's still a ton of pad life on them after my 1 track day.
I've used hawk hp plus with a CSL rotor setup for about a decade now and have been very happy. They fit my needs well.
Hawk ER1. They’re fantastic.
Hawk 5.0 for street/autox. I like them but they do make a fair bit of dust and maybe a little underpowered for heavy track.
I've been replacing the brakes on my 2019 since it hit about 25k or so, rear have been done twice (I'm at 62k now and just did them the second time) and the front were done around 30k. My dealership outright told me Mazda brakes are garbage and these vehicles are not made for Canadian winters (regardless of what their advertising says). This new set is aftermarket so hopefully better but seriously my brakes have been so corroded it's unbelievable.
Write your review
Help others - share your experience with this part.