Brake pads OEM Mazda or OEM Volkswagen
Over the weekend I finally got the brakes to cooperate, so it's just about time to get a few test runs in.
I did our Atlas rear brakes without a scan tool.
I have done the all the brakes on our 19 Atlas myself. Like previously stated fronts are straight forward and easy.
No, no scan tool is needed at all for the fronts. They are basically the same as any other brake job. I actually found them easier than my other vehicles
I’m on 108000kms in my 2017 GLI and it runs like the day I bought it. I do the maintenance on time when needed and it is trouble free. So far all I’ve had to do is the brakes.
Had the same scenario with my cx30 after changing the brakes, only the car messages were things such as engine malfunction and dynamic control malfunction which is ridiculous. Clearing the fault using a Bluetooth obd and the torque app was enough for me, thanks for the post.
I'm kind of disappointed with the factory VW pads that came with my 2019. My 2013 ran for 120K before the brakes needed replacement. Also, these pads leave a lot of brake dust on the side of the car.
I've been replacing the brakes on my 2019 since it hit about 25k or so, rear have been done twice (I'm at 62k now and just did them the second time) and the front were done around 30k. My dealership outright told me Mazda brakes are garbage and these vehicles are not made for Canadian winters (regardless of what their advertising says). This new set is aftermarket so hopefully better but seriously my brakes have been so corroded it's unbelievable.
brake screech that's omni present
I put OEM Brakes on my ‘19 3 GT AWD. I’m 20K KM into them, and they pulse like mad when I brake above 90KM/h. Absolute fucking trash. The factory brakes also did this, above 90KM, but started around 50K into their life.
Write your review
Help others - share your experience with this part.