I am running the power stop cross drilled and slotted with carbon fiber and ceramic pads. But it is only because it was so cheap I couldn't pass it up.
I recommend Powerstop pads and rotors. I’ve had their pads for about a year and the pads are about an 8th worn. They say they’re carbon fiber infused but I don’t know how accurate that is. But they feel great and for performance rotors they offer a lot of bang for your buck.
Im using Zimmerman coated blanks with PowerStop ceramic pads. I've had them for about 12k miles front and rear without issues
This is the pad I'm using on track. I use Z26-1001 on street. If you search by pad on Powerstops site, it shows you all the cars that use the same pad. They don't have the Macan listed, but I can confirm they are the correct pad and you can see that almost every 4 pot Brembo OEM system uses the same pad.
For brakes, I have Power Stop on all of my cars. But I've heard nothing but good things about Akebonos too.
I have Power Stop all around on my daily driver - a Pontiac Vibe base. Z17 Ceramic pads in front, Geomet-coated rotors (note that the coating will wear off quickly where the pads contact, but it does keep the rest of the rotors from getting rusty), and OE-style semi-metallic shoes in the back. Stock calipers. Not sure how they do with more spirited driving, but I think they work very well for my daily. No noise, no noticeable dust, good braking power.
I'm REALLY picky about brakes... I've been down this road more than a few times and finally settled on Powerstop Evolution pads... they bite really well, warm or cold weather, and they don't eat the rotors alive either I think they are the best street pads I've found to date.
After 70K miles of fun driving, I finally replaced my front brake rotors and pads...3mm left on the pads LOL. I got Zimmermann Rotors($180) and Mintex pads($45) and couldn't be happier. In fact, this set-up feels a lot better than the OEM bite and feel plus the massive reduction in brake dust.
I recently got a pair of pretty rusty 325 calipers for £50 (mine are the smaller ones from a 316) and sandblasted them back to clean metal. Then painted with high temp paint and rebuild kit £30 (pistons, seals, guide pins, bleed valves etc). I was pretty happy with the result which cost me around £100 for the pair. I then went with mintex discs and pads and a full set of braided brake lines my mate had. Full refurb prolly cost me £300 and are significantly better than they were but I don't think they will be as good as a 4 pot setup.
mintex red-box suck, you want a set, I'll give you mine. I have had mine for about a week they are ok for grandma style braking, but once you really get on them, you are srewed for an hour (of light braking).
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
