Brake pads STOPTECH or Hawk Performance
Have your brakes been broken in properly? It could be that, I replaced the brakes on Face's car and they had the metal on metal sound for abit till they got fully broken in. The creaky type noise could be your wheel bearing.
I just had my brakes done all around, ATE rotors with Hawk HPS pads FTW, very little brake dust and my isht stops on a dime. I had my fluid flushed too, this upgrade was def worth the money
For my track setup I'm also running Hawk HPS pads out rear, very similar to the characteristics of the R4-S. I've run the R4-S before and prefer the Hawks.
I just installed Hawk HPS pads front and rear about week and a half ago. I did a 300 mile drive up in the twisty mountains here over the weekend and absolutely love the pads. No noise, very little dust, good feedback, cheaper than the Porters.
21K Ferodo DS2500/Hawk HPS - excellent grip
I've owned an 01 225 Coupe for one year this past November. It's an AMU motor code and I love the car still. These are the things I have had to replace so far, not counting upgrades: Brakes & brake fluid & front rotors (Hawk HP, ATE superblue) $350
At Sears Point, braking from 90+ three times per lap (2, 7, 11). Stock GTI vented rotors "work fine" with good fluid and Hawk Blues.
My old one... gotta get a new one... AP Racing 12\" - Hawk HP Plus pads - AP Racing (was vented) rotors
I had a track day yesterday and I think my rear brakes are overheating. The rears are 9.1" solid rotors with Hawk HPS pads. The edge of the pads close to the rotors turned an orangy-brown colour and smelled real bad after my last session. I'm pretty sure it is overheating.
I decided to go with the Hawk Ceramic pads and I am now regretting it. The pads give off near 0 brake dust but that initial bite the OEM pads had is gone.
Write your review
Help others - share your experience with this part.