I just replaced both of my assemblies with Hella's from FCP. cost me about $260 for both housings and they came with all the bulbs. just make sure all of the bulbs are installed properly. one of my projector beams was not snapped in all the way so the cut-off didnt looks right. Just had to re-seat the bulb.
As GTI's indicated (and he must have known I'd jump in ), that beam pattern is perfectly normal for OEM Mk5 halogen reflector headlights.
Not sure about the taillights, but the OEM headlights are made by Hella. I would recommend you search for Hella brand headlights.
I installed TYC headlights for $170 from rock auto. I can speak for the TYC lights being good.
I have a set of my 9th gen si and fitment was damn near OEM.
I replaced my worn out cloudy/mildewed headlight bodies on my 2006 CVPI with these TYC replacement OEM-look headlights from Rock Auto. So far, they've worked really well for the 4 months I've had them installed. No leaks/condensation or short circuits/failures. They were really useful on long drives (4-6 hours) at night or early morning where there aren't any streetlights for long stretches on the highway. The only complaint I have is the "high beams" just seem like a change in point of aim (higher), rather than increased illumination.
I’ve used TYC and they were good. I couldn’t tell any difference between them and oem.
I’ve got TYC headlights on my V50. It all works and fits but the quality is definitely lower than oem, but it works and its a lot cheaper so its worth it if you are on a budget. Would go oem next time though
TYC headlights are trash and their sealant is the main cause of letting moisture in.
it's been driving me nuts that I've been getting condensation only in my passenger side headlight. They're brand new TYC aftermarket headlights and I have another friend with the same exact issue. Same brand, same side.
It's not leaking or anything. Just your typical condensation that doesn't go away lol. I've checked the breather valve (valve for venting the heat) and while it looks identical to the driver side, the holes are pretty small. I'm guessing it's not enough for the hot air to vent out, hence the condensation.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
