MOTORAD 7416203 with 203 temp is good.
The SNN-2000-195 model is good and I have zero complaints about it. I've used them for awhile now.
All I could get on short notice was a motorad...been in there over a year now and haven't had an issue. It's an OE 195 temp and seems to open around 205-210.
I found an exact copy of the factory thermostat with the baby one next to the primary the Amazon description says it’s good up to a 2000. It’s a Motorad. My temp never moves from the set point.
I remembered the old thermostat looking like it did, so I waited a few hours to let the engine cool down then swapped the new thermostat for the old one, turned the engine on and no overheating. I've been driving the car as it is for a while now without any problems other than I can't drive long-distance without it running too hot (ex. I drove 4 hours a couple times a year traveling for college, and in the summer the car sometimes would overheat by the time I got to my destination).
I did notice before I recently got safety/emission test for plate renewal, i wanted to confirm the I/M readiness had ran, that at idle, the full trims were extremely rich. I'm leaning towards the lower tstat having something to do with that. I have a 195 motorad(blah) that i had just installed before the plenum work. ECT didn't break 178 degrees on a highway cruise at 95+ degrees. That seems to be right at the threshold for the current dtc.
I have had brand new bmw thermostats not work and cause my car to get hot on the highway.
I bought a 2022 X4 about a month ago from BMW. Had it for 2 weeks and got the same notification. Took it to BMW ( I got the warranty) and adjuster came in from the warranty people on Monday but haven’t approved the repair yet. They said it was also a thermostat. Seems like this is a common thing in these cars ? Mine is at 61k miles, bought it used and only had it for 2 MF weeks.
I had issues with the MotoRad that every parts store in Canada seems to sell
issue that i noticed is that the jiggle pin is inside the bridge, compared to the standard one. i have installed the thermostat, bled the coolant, and still made sure that the jiggle pin and head gasket carve out lines up at the 12oclock position when installing; but now theres some ticking noise sometimes and i can feel my heater blowing really hot air (warmer than the usual heat).
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
