vs
Timing belt Mitsuboshi or Contitech
Reviews
My mother had an '86, then upgraded to a '93 Pajero (so euro) 2.5TDI GLS. Not what you're looking at but I'll share some stuff FWIW. She sold the '93 in 2010. It was a pretty good car. Big and slow, but surprisingly comfortable, especially in the front. These are not as refined as a Range Rover etc, and they feel a bit like farm equipment at times. Got around really well in snow and cold with its advanced 4WD system, could put it in 2WD and get power oversteer too (I managed to smash a fence this way). Interior never felt top quality, but held up really well in terms of wear and tear. Floaty steering feel, squishy manual gearbox, easy clutch, squishy but decent brakes, turbo lag diesel engine. The timing belt snapped (probably because the mechanic did not replace it properly) and the head cracked, which cost a lot of money to replace and was difficult to source. Overall, not a great driving experience, but a decent and solid car that will do whatever you ask of it without grumbling.
Pros: surprisingly comfortable, held up well
Cons: floaty steering, turbo lag
Vehicle:
Mitsubishi Pajero
As an alternative to a chain drive, timing belts also markedly reduce CO2 emissions. ContiTech developed the CONTI® OIL RUNNER™, which runs like a chain in oil and holds out for the entire life of an engine.
Pros: reduces CO2 emissions
my dad has a 97 and that car has been pretty much great to him. never had a tranny issue or a head-gasket. the only problems he has had are have the timing belt snap on him (we think due to improper installation), leaking valve cover gasket (it is a PITA to change) and a heater core leak nothing insane though.
Pros: pretty much great
Cons: timing belt snap, valve cover gasket leaking
Vehicle:
Mitsubishi Montero
i just put this kit on my 1.8t and no issues after about 2k miles. From what I hear the contitech stuff is actually better then oem. Im not really impressed with the oem stuff anyway.
Pros: no issues after 2k miles
Cons: not impressed with oem
Mileage: 3218 km
My Audi 20v five potter uses the same tooth profile as the 16v but the t-belt is the 19mm wide flavor. I've never minded ripping that thing up to 7K and feared that the belt would'nt hold up... even withe the 4 extra valves and the waterpump running off that belt!! I'would'nt panic as long as it gets replaced when it's due. Oh and don't get me none of that cheapo stuff either.. gotta be ContiTech or Gates!!! And don't spill oil or grease on any belt!!
Pros: holds up to 7K
Cons: replace when due
Vehicle:
Audi
I changed with new belt but it is also a half tooth. It always lines up with cam cover arrow just at the line at the end of the tooth rather than middle of it at tdc.
Cons: half tooth off
Write your review
Help others - share your experience with this part.
Comparisons
Show all
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page