Just discussed this last week. I side with my VW dealer on it. They recommend just replacing the rotors, its really not that much more than having them turned, considering you almost guarantee no pulsation, no shimmy or shudder and more even brake wear.
Engine braking is how I got 60k miles out of the original brake rotors and pads on my '07 GTI as well as a steady 30 mpg while barely trying.
Rallye 1.8T you are the man! Thanks for the tip and saving me a lot of time and money. The mk5 312x25mm rotors work on my setup. Only thing I have to do is run one thin washer between the bracket and spindle.
having a vac at idle is NORMAL... its exactly how it was designed to be... vacuum is drawn on the head and block from the manifold via the PCV system... you test it by taking the pcv off and trying to force air through the valve. if it goes through, its busted... if it doesnt, then your fine.
@tbomb, that's old school thinking. You can easily change the gapping, just don't be retarded and slam a coin or something in there and start bashing away. lol
we did an AutoX last month and i even had the better times. they arent all they are cracked up to be.
This problem started after I changed the rear VW brakes rotors and rear VW pads and changed all four wheels with remanufactured VW Phaeton wheels.
Some people will get an error when trying to get their xenons to go into adaptation mode. I played with my setup and got a MIL. My rear level sensor is a good bit off, so it throws my xenons off no matter what. Ill need to tap a new hole and play with positioning in order to get the measurement back to where the car will auto adjust again. Ill let u guys know what I come up with, along with a really easy to follow write up.
Unfortunately the problem is inherent in the design of the rotors. Not in where they were produced. You can put the best rotors in the world on that car and they will still warp. Vw/Chrysler would need to spec a larger and thicker rotor to help dissipate heat properly. All aftermarkets will make the rotor to fit, based on the crappy oem specs. So, get used to having new rotors put on...because recall or not, Chrysler still needs to redesign that rotor. FYI, I'm in the same boat as you guys! These rotors suck!
Yeah, I gained a stunning 1 WHP with a D03 nozzle with my DVC-30 kit. :laugh:
Write your review
Help others - share your experience with this part.
Brake discs Zimmermann or POWER STOP
Brake discs Brembo or Zimmermann
Brake discs Brembo or POWER STOP
Brake discs Zimmermann or Centric
Brake discs Zimmermann or STOPTECH
Brake discs Zimmermann or OEM Volkswagen
Brake discs Zimmermann or EBC
Brake discs Zimmermann or Raybestos
Show allVoted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
