I had this problem too and I saw in other forums quite a few other people as well. I used Bosch pads too I think (can’t recall right now) but when I compared them to the OeM ones I removed, there was a difference similar the the gaps you pointed to in your pic. Putting the old OEM ones back and the gap is not there. So what I ended up doing was simply added a bit of shim to one side of the Bosch pad to take up the gap and the problem went away. I put the shim only on one side, the side that would be compressed when in reverse. FWIW others have tried other brands of pads and they all seem to have the same issue. Apparently the only ones that don’t are the OEM ones for some strange reason. When I compared mine, it wasn’t the pad backing that was causing the delta, it was the shim.
I'm very happy with Bosch QuietCast pads and rotors.
I went aftermarket with centric posi-quiet pads or Bosch quiet cast. Won’t ever go back to factory.
I used ATE ceramic pads on my mk7 pp and so far they are great. Barely any dust, no noticeable wear on the rotors after 3k miles, and no extra pedal pressure required.
I did Bosch quiet cast pads and rotors on the front on my 12 a couple months back. I’m happy with them.
Brembo, bosh and a few others mentioned in another comment are all really good too.
I got the Bosche pads. I think they were in a higher category than daily but the front+back together ended up being cheaper then other brands I was looking at. Just make sure you get ones clearly labeled front or back, and Japan built.
I got BREMBO rotors and Bosch quiet cast pads, happy with the purchase.
Just a word of caution, I ordered Bosch pads off of RockAuto and received off brand pads wrapped in shop towels in Bosch boxes. Still put them on and they're alright, but not what I bought. Wasn't worth it to me to send back. Not RockAuto's fault, they have third party suppliers. I'm sure they would have taken care of it had I cared enough
For my (owned 3 years, purchased used) 2014 Honda Crosstour I've always had to grind down the edges of the pad mounting plate tabs on Bosch brakes a couple of mm to get it to fit into the calipers. I have just received a new set, and while I still had to grind down the edges to get them to slide into the calipers, the top and bottom edges were MUCH shorter than the previous pads. So much so that when braking after reversing direction, the pads will shift in the calipers with a noticeable 'click' as the brake pads engage the disks to slow the car and are thus moved to the other end of the caliper. The overlap between the brake pad plate and the 'C' in the caliper where the tab meets the caliper is only 2mm or so. Definitely less than I am comfortable with.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The tires OEM Fiat got the first review!
The ABS unit OEM FORD got the first review!
For oil additives LIQUI MOLY already 25 reviews.
For tires GISLAVED already 25 reviews.
In the rating best cabin filter already 13 brands participate!
In the rating best shock absorbers already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the auto rating shock absorbers for Ford Ranger already 20 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating tires for Toyota Corolla already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
