Brake pads Bosch or Hawk Performance
Hawk DTC 70 or 60 are great and not too expensive, plus they didn't squeel for me on the street.
Hawk 5.0 Street Pads, if u want to do a mix of street, spirited and track driving, I run them on my GR86, and no issue. Though they do squeel a bit when its cold out.
i run HP+ for track days, will be doing my 4th on them in a few weeks. they are plenty for my level of driving. i take them off after my track day because they are loud and filthy. but for on-track, they are perfect.
I have dtc-60 on mine. They’re great track pads, but overkill for your first track day. They’re comically squeaky if you use them around town and def not made for that.
I run the 60s in the front and stock in the rear. The 60s are a lot of braking power specially for your first time. I would not recommend the 70s that will be way too much. They are dusty but I'm at about 50% life on 5 track weekends. One weekend the car almost never shut off. If you are really using them make sure to give them a cool down lap or they will smoke.
I have the dtc60 with rbf600 fluid. No fade at all. Would recommend. If you're tracking only once a year though, make sure to swap back to street pads. The hawks dust a ton and squeal veeery loud.
Been on Hawk HPS 5.0 for over a year now. Good feeling pad.
You could look at Hawk Enduro pads and see if they last longer but you'll probably net less braking power so you'll need to recalibrate your markers a bit. 3100lbs and 300hp - dtc60s last me 8-11 track days (though one of my local tracks is easy on brakes) based on my experience last year running in advanced groups - including multiple open sessions with 30-50m long runs.
I replaced front pads and rotors on my Tiguan, and afterwards, when going between D <-> R and applying the brakes, the first brake application causes a "clack" on both sides at the front. Pads are Bosch 1633A. spring clips (integral to pads) are seated properly. Pads and rotors were bedded properly. Wheel lug bolts torqued properly. I have the official instructions from VW. I've probably done ~20 brake jobs in my life, mostly Volvos (over half of those were sliding-caliper designs like the Tiguan's). What I tried (with no success): searching and searching and searching forums, only found 2 other people with a similar issue on FCP's Brake Replacement YouTube video measured and compared all latereral dimensions of the pad's plate between new and old, same dimensions re-installed the pads all bolts are torqued properly (caliper carrier 200 Nm; caliper pin bolts 35 Nm) found a Tech Bulletin from VW that mentions there are inner- and outer-specific orientation for the pads. This appears to apply only to the Genuine (labeled TRW) pads, as all 3 Bosch pads are identical in every way that I can discern bought a set of Genuine VW pads (labeled VW), ensured the correct orientation of pads according to the Tech Bulletin, and they still clack. pad backing plate dimensions are the same as the Bosch. Ack! More money! bought a set of genuine caliper carriers (with the thinking that perhaps when I wire-wheeled the old caliper carriers to remove rust, it took off too much material). I didn't install them because I measured all the dimensions that interface with the pads and the new are identical to the old.
I changed out the oem and ran Hawks for a while, braking distance wan't much difference but the brake dust was terrible, Rims where dirty all of the time.
Write your review
Help others - share your experience with this part.