Over the weekend I finally got the brakes to cooperate, so it's just about time to get a few test runs in.
I did our Atlas rear brakes without a scan tool.
I have done the all the brakes on our 19 Atlas myself. Like previously stated fronts are straight forward and easy.
No, no scan tool is needed at all for the fronts. They are basically the same as any other brake job. I actually found them easier than my other vehicles
I’ve had stock set up, powerstop rotors with Hawk LTS Truck/SUV pads, and my current set up is Bosch severe duty pads with Advics premium rotors. So far the current set up is my favorite. I really prefer the immediate “bite” of semi metallic pads.
In comparison to the stock setup, the Bosch QuietCast pads and rotors aren't as touchy or responsive. They do require a little bit more pedal travel for normal stopping power. However, they do offer more precise control over how much power is applied throughout the pedal stroke. They are also incredibly quiet and smooth.
I’m on 108000kms in my 2017 GLI and it runs like the day I bought it. I do the maintenance on time when needed and it is trouble free. So far all I’ve had to do is the brakes.
It's the pad compound and v. common for VWs. Often first thing in morning when there is moisture on them and moreso in reverse. You can do new pads and use something like a ceramic compound, it's a cheap fix.
For my (owned 3 years, purchased used) 2014 Honda Crosstour I've always had to grind down the edges of the pad mounting plate tabs on Bosch brakes a couple of mm to get it to fit into the calipers. I have just received a new set, and while I still had to grind down the edges to get them to slide into the calipers, the top and bottom edges were MUCH shorter than the previous pads. So much so that when braking after reversing direction, the pads will shift in the calipers with a noticeable 'click' as the brake pads engage the disks to slow the car and are thus moved to the other end of the caliper. The overlap between the brake pad plate and the 'C' in the caliper where the tab meets the caliper is only 2mm or so. Definitely less than I am comfortable with.
Just got back from the dealer who did an inspection and acknowledged the problem and that it was widespread. However, \"all they can do it tell you whether they're safe or not\". Of course, they're safe but they are also embarassing and, to my wife, anxiety producing thinking that the brakes are about to fail. It's an indictment on the factory that they would allow so many reported issues to go unaddressed, and that they would use ****ty brake pads.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
