Brake pads Brembo or OEM Subaru
I use brembo pads from ecstuning.com , dont buy parts on amazon or from china when you have a much better source available. I have ECS's own 2 piece rotors on front and brembo rotors on rear, my braking is really powerful and has lasted a long time despite what people say about ceramic pads and drilled/slotted rotors
I’m my 2019 Forester, I hit 70k miles without changing either fronts and rears. The fronts now need to be done. Hard to argue against OEM with that performance.
Brembos are super dusty, amazing pads but they leave my alloys covered in dust within a week.
after testing fancy slotted EBC brakes with greenstuff pads
i decided to just get something more like OEM and got myself a set of brembo pads and max line rotors, perfect for me.
I was hugely disappointed, because the pads are great. TBH, it's basically a low- to mid-tier race pad, so the price is not that ridiculous. I put quite a few track days on them and after trying out some other aftermarket pads, I actually went back to the OEM pads for 3-season street use.
They feel very similar to the original pads, so much so that I wouldn't be surprised if the original pads were supplied by Brembo on the performance pack.
They’re fantastic. Got a set when I swapped in brembos last summer. Amazing braking power and minimal fade.
4 years ago I had my daughter, before taking my 2008 Mazda 6 back to college with her, install new Brembo "OE"/standard type pad sets front and rear and new Brembo rotors in the front. The front pads and rotors were so thick that the caliper piston cups had to be ENTIRELY retracted into the pistons to fit over them. After completion of the job and the performance of the pad/rotor break-in procedure, the already capable car was turned into a braking performance monster. It was like if you depressed the brake pedal a millimeter the car would start to decelerate markedly! And rapid stops were unbelievable quick and drama free. So I absolutely recommend Brembo products (have installed Brembo pads on 2 SUVs as well) and have always been impressed with the results!!
I had an 2017 Outback 2.5, had it since April of 2017 until last week, during that time I put on 93k km on it. I wish I had gotten the 3.6, I got the 2.5 hoping to save fuel, my average was around 25mpg for lifetime, and I drive a lot on hwy and country road, I never once was able to hit the 30mpg even if it's just me in the car and driving 50mph on the country road, this part I really feel like Subaru should correct their mpg reading, in winter it can get as bad as 18mpg in the freezing weather, as when it's cold the transmission will make the engine constantly rev at higher to warm it up, the 2.5 is also not a smooth engine when at idle, I had a vibration issue that was deemed normal. Overall, it's a reliable car, but its not a durable car, another thing is, when taking off quickly from a stop, it can really bog down, most people are used to first gear and just boot, but these CVT don't have first gear and it can be rather unexpected, I've almost got hit from behind a couple times from that. The eyesight is a good feature, the lane departure can be annoying at times but I was ok with it, these cars have an issue with windshield chipping, and if the car has eyesight, the windshield need to be a specific one and then the eyesight needs to be re-calibrated, this happened to me TWICE, and it got expensive very quick. OEM tires are lousy, by lousy I mean it doesn't even get good mpg, doesn't get good grip in ANY condition and puncture easily if you take it to any sort of gravel road, I had puncture the tire within 1200km, I just got some decent A/T tires after, no problem for the last 90k. The brakes are soft, so first thing I did was changed the pads.
I stepped up to Brembo pads on my A4 and they are nothing to write home about performance-wise. They also dust like no other pad I've used.
Write your review
Help others - share your experience with this part.