Brake pads Carbotech or OEM Toyota
Been running carbotechs on my m2comp and C's and 2 seasons. Love them. Xp10 up front, xp8 for the rear. Track only pads that I can drive to the track with
oem for toyota brakes everything else makes noise for some reason
I have 112,000 miles on my 22.LE and no issues so far I even have original brakes
I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.
I stick to oem pads and rotors because they last a very long time.
I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps
XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this
I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.
I run carbotech xp8 on the front of my c5. Still a group 2 level driver. They’re a good pad for a car that’s driven to the track and home, but dirty and noisy at times for a street pad. They’re considered entry level track pads. I chew up rotors but don’t get fade, but my local tracks aren’t particularly hard on brakes
Just changed a 4Runner with 80k miles, the pads were worn flat all the way down.
Write your review
Help others - share your experience with this part.