Brake pads DIXCEL or OEM Honda
Upgraded rotors (paragon 2 piece) and dixcel type z pads.
I am easy on brakes. I coast to stops and don't speed either. I have a 2009 Fit. I swapped the front pads and rotors at 120,000 miles just because. They totally did not need to be swapped. I have since put 97,000 miles on the replacement pads and rotors. The ceramic pads I installed have plenty of life left. The rotors are near the end, but still work.
I put 68k on my 21 accord in about 2 years. Pads were all at 7mm. 80 percent highway, 20 percent city.
Dixcel m pads good stopping and ultra low dust.
For years my brakes on my CRV squeaked. My dad replaced them. A few other people/shops worked on them. Still squeaked. I'm talking YEEEAAAARRRRRS. I resigned myself to being *that person* at every friggin stop light. Needed new brakes again. Unique situation as it was, the Honda dealership ended up doing it. It was like $500 but they stopped squeaking!!!! It was heavenly to be a silent stopper.
Stock calipers with Dixcel SD slotted rotors and Dixcel ES pads.
Impressively even wear. Got every bit of life out of that set.
Seeing what looks like a Prelude wheel, why not just get the OEM honda brake pads? They are acceptable for most daily use, and the brake dust isn't to terrible to deal with
The brakes were so-so, and it had lots of torque steer, and benefited greatly from an aftermarket and much stiffer rear ARB, which improved its turn in and corner habits tremendously.
If there's a sore point on the Si, it's the brakes. It's that initial application is far too touchy, making smooth heel-and-toeing difficult especially when only light brake application is required. That abruptness proves annoying even in hard use, and the slightly spongy pedal feel doesn't help matters.
Write your review
Help others - share your experience with this part.