I have project Mu pads and rotors, front and back on my 33 GTR. They’re fantastic products. But be warned, they’re gonna squeak. Sometimes badly. Having said that, it’s *because they’re good* that they squeak. They’re pretty much racing brakes, and if you’re not hearing them up high enough, they’re gonna squeak. So be prepared for that.
I got PMu Street Comp pads and rotors on mine, about a couple weeks ago. They are solid, definitely highly recommend the brand.
I replaced the pads on with Endless MX-72. Similar progressive bite to OEM, just more and WAY more thermal capacity. They feel like the ultimate brake pad. Using OEM rotors, I've had zero \"warping\" since switching over. This leads me to think that the rotors aren't actually warping but the nature of the OEM pads leads to pad deposits on the rotors. I get close to 60,000 Miles out of a set and have never considered another pad after discovering them.
The street type are great all rounders, reasonable bite and minimal drop off. Pretty low dust and noise, and wear was terrific. The set I had lasted longer than the oem pads I had before them. The performance of the track orientated pads is absolutely insane. The initial bite is like no other pad I've ever had. It drops off a tad but still great stopping power. However dust and noise are pretty terrible.
I run the Project Mu HC+ and DBA4000 rotors on a FK8 CTR that is also daily driven. over all very happy works ok when cold but 1 or 2 stops and its up to temp and has great bite. and really only minor pad sequel when stone cold.
I just put on some Endless MX72s. But they are for performance street and occasional track use. And they are not cheaper or probably less noise. But I do expect a great deal better wear with them than stock.
Not cheap, but Endless makes perfect street pads that last a long time, are quiet, very little dust, good cold bite, and high coefficient of friction and heat range.
I bought some Endless SS-Y's from FR-sport and they're way better than the stock pads in every way. They don't even cause dust.
The best solution I have found is to use slotted rotors--cryo treatment typically gets me 10K more miles before hard spots develop and I get a pedal vibration--and an aggressive pad without any ceramics. My solution is to use the best quality slotted rotor I can find, cryo treatment preferred, and use either a Wilwood BP-10/20 pad or a Project Mu NS brake pad. I found those two pads were aggressive enough to have great stopping power and would wear out the rotor at the same rate the pad wore down.
I personally use Project Mu HC+800 for their fantastic cold bite and high temp resistance.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
