Brake pads Ferodo or Mintex
I ran with Ferodo DS2500s. They work incredibly well for light track use (my street tires overheat before the brakes ever fade), they are dead silent, and, somehow, very low dust. They are more expensive than most other pads though and probably excessive for most people in their capabilities.
For brakes I run Scirocco 10.1 fronts with Mintex red pads, MK3 200mm rear drums- i used to have to be careful when I ran 195/50/15's because of accidental lock, but it's much improved with the 205/50/15's (Toyo R1R's- best tire i've had).
I upgraded the pads and rotors to drilled Zimmerman discs that I painted black except for swept area and Mintex pads from Autotech.
For future reference I use Mintex pad all round (occasionally Pagid) Cross reference Front Pads MDB 2601 Rears MDC 1924 Front 365mm Floating Discs VW PATTERN PART ONLY!
front - 9.4in vented rotors ferodo ds2500 fastroad pads rear - swapped to discs mk4 calipers ferodo ds2500 fastroad pads
I had a similar problem years ago with a set of Mintex pads. This might not be the recommended way to fix it, but I just rubbed the brake pads on the concrete floor to wear them down a little so they fit...never had a problem with them after that.
overhauled the brakes(all 4 corners): -calipers(rebuild) -discs(brembo) -pads (ferodo ds2500)
I've heard there was in issue with this with mintex pads for the Passat. the red boxes would just start up under high heat
I'm running the same setup as you (Ferodo DS2500/Hawk HPS with ATE Super Blue) and also notice some mild fade after 6-8 laps. I also get a mushy pedal which persists after the brakes completely cool, meaning I'm probably getting some fluid boiling and need to bleed them out.
These are some TERRIBLE brakes, I almost got into a couple of major accidents because these brakes completely overheat and stop working. I will never buy Mintex again.
Write your review
Help others - share your experience with this part.