Brake pads Hawk Performance or GALFER
I ran the Hawk HP+, and had no complaints. Never did a whole lot of hard driving, but they held up in short bursts and were good for daily driving.
I’m a fan of the Hawk HP+ track pads! The bite and fade resistance is excellent. They’re a little squeaky on the street but not terrible.
For last Autox season I used the factory calipers. Hawk blue pads, motul brake fluid. Had no issues at all.
I autocross a bit and went with Hawk rotors and pads from Tirerack after a bit of mulling it over. Overall fairly happy with them, a little dusty but have NEVER faded while on them hard. Put maybe a hard 5k miles on them so far.
edit- I do have a 1.8 and as mentioned at least once you should consider getting the 1.8's calipers.
I run hawk hps pads on my NA. They've held up to entry level track work and not made much noise on the street. Feel fine when I choose to drive the Miata to work.
Just switched from Stoptech street pads + stoptech drilled and slotted rotors to zimmerman cross drilled rotors with hawk hps5.0 pads. Must say I like my Zimmerman + Hawk setup a lot.
I have been running Hawk HPS 5.0 front and back since my 2019 Stinger GT. Put them on my G70 within the first 500 miles to save the rotors. They do squeak a bit, but they stop without fail and after 35k on my Stinger, never once did I get any vibration on braking.
Hawk hps ceramic pads
I swapped from the ake’s to hawk on the last pad change. Hawks definitely don’t have the same stopping performance as the stock ones. I hate the dust from stock, but they work so much better Wouldn’t say the hawks were unacceptable by any means. Not worth the trouble to pull them out, but won’t be using them again
Garbage pads. They're like a damn on/off switch and they chew through rotors.
Write your review
Help others - share your experience with this part.