Brake pads Hawk Performance or OEM Chevrolet
Hawk LTS improved the pedal in my 460, and unlike power stop, Hawk isn’t the laughing stock of track day communities
I have Hawk 5.0 pads with KnS standard rotors and they've been pretty great so far.
I’d used hawk ceramic pads especially since you don’t plan on tracking the car. Low dust and will keep the wheels looking good between washes
They don't even squeal as much any more
Hawk DTC-60 pads are the best value performance pads I found. Stock blank rotors are fine, I upgraded to a 335i sport caliper set and its been more than sufficient for many track days
EBC for occasional track and daily pad. HAWK DCT60 is what I’m running. Stops so good!!
I ran hawk hp+ pads last year before starting my first track season ever. After 7-8 track days, driving to and from track, and the occasional fun drive on the street. About 10k miles later, I swapped them for fresh hp+ pads for this year. Comparing the old vs fresh pads, I used about 50% of the pad.
Get some Hawk HP+ pads and you’ll restore the balance.
They’re noisy and nasty and will ruin the wheel finish, but they grab hard.
I've used hawk hp+ all last year and my first event of this year; they do serve as a pretty good intermediate pad, if I were you I'd go after something similar to it or slightly more track-oriented, but as I understand it the "HPS" pads are not designed for track use, more of just a capable street pad. The HP+ feel great for street driving, but be aware that they do create a fuckton of dust, and oftentimes they squeal like a school bus as you come to a stop. On track, I'd say they do fine for a beginner. I tend to brake on the early side and not as hard as I could, it's an area where I could certainly improve. I have noticed some brake fade at my most recent event, and for that reason I will be installing some G-loc r8's tomorrow, with a backup set of R12's for the front.
That's normal for those. I have been through 3 or 4 sets now and to be honest, I think I'm done. After COVID they just seem to be very unpredictable. I've my last set did some weird stuff sometimes and my current set feels like it needs way more temp then it should. When I did a track day and put dtc60s on it, they gripped immediately on a cold stop where the HP+ felt like it needed some use. None of the other pairs have felt that way. The noise is also totally random now, the first couple sets would be loud unless they had heat, but the new ones are a lot quieter and sometimes loud.
Write your review
Help others - share your experience with this part.