I am stock turbo FBO (engine wise) FiST, switched from Powerstop Trac Day Spec to Hawk DTC-60 with good results.
I’m a big fan of how my brakes feel after upgrading to the Hawk HPS 5.0 pads, Bosch solid rotors (drilled/slotted do more harm than good), and some Goodrich Stainless Braided Brake lines.
Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.
For my 2016 V60 I only spend about $500. Also depending on your rotors and pads, there's no need to do both front and rear together.
I replaced the front pads myself after 25,000 miles (was 2 years ago), it cost me under $200, including all the necessary tools and original Volvo pads.
Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.
Hawk hps 5.0 and blank Zimmerman rotors
My focus rs has been doing this. I’m on OEM rotors with hawk dtc 60 on front dtc30 on rear. It performs fine on the streets and around town. When I take it to the track it starts to judder, noticeable 5 mins in but at the end of 20 min session it gets a lot worse.
Motul RBF600 is a popular fluid choice.
pad choices are far and wide. i run hawk HP+ which isnt really the best track pad but its gotten me by. the paint on the back of the pads melted off before i ever felt fade so i guess they worked well but i suspect im *at* the limit of their performance.
I ran Hawk DTC60's for one event. They dust like crazy which isn't the end of the world by itself, but if the dust touches any moisture at all (like the rainy track day) it mixes into what I can only describe as ferrous concrete. So not only is the dust-crete impossible to remove by any normal means, it then rusts like crazy, turning whatever wheels you have into a runny orange mess. I tried multiple different wheel cleaners, multiple brushes, soaking, anything and nothing could get it off. I had to use scotch brite and scuff the hell out of the wheels to get it off. Fortunately I run cheap TRM wheels and it's a track-only car otherwise I would have been livid.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The tires OEM Fiat got the first review!
The ABS unit OEM FORD got the first review!
For oil additives LIQUI MOLY already 25 reviews.
For tires GISLAVED already 25 reviews.
In the rating best cabin filter already 13 brands participate!
In the rating best shock absorbers already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the auto rating shock absorbers for Ford Ranger already 20 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating tires for Toyota Corolla already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
